6. Tie off the seam as follows:
How to Thread the HandyMender
Thread the HandyMender following the numbers as shown below.
a. Pass Threader through the last stitch. b. Place the thread into Threader.
c. Pull out about 1 inch.
d. Slip the thread through the loop and pull it tight to finish the seam.
NOTE: Thread should flow from the bobbin or spool as shown: (The spring must be in place before installing bobbin.)
Use threader to pass the thread through needle eye from rear to front.
Adjusting the Thread Tension
∙ If stitching is too tight, turn the tension control nut slightly to the left
∙ If stitching is too loose, turn the tension control nut slightly to the right
9 | 10 |
