3.Pull at least 2 inches of thread tail through the needle prior to starting to sew.
4.Hold HandyMender in right hand; press power switch with your thumb; use your left hand to guide the fabric.
5.When pivoting or turning a corner, the needle must be lowered into the fabric.
How to Finish the Seam
1.When finished sewing a seam, raise the Needle Arm by turning Hand Wheel. Then, use the back of the Seam Ripper to pull the thread out about 3 inches; cut leaving about a 3 inches tail.
7
2.Turn the Hand Wheel, lowering the needle into the fabric. Continue to turn the Hand Wheel until Needle Arm is again at its highest position.
3.Lift up the Presser Foot and take off the fabric to the left. Be careful not to pull the thread or the seam will ravel.
4.The top of the fabric will have a 3 inches thread tail and the bottom will have a small loop.
5.Turn to the bottom side of the fabric and with the backside of the Seam Ripper inserted into the loop; pull the thread through the fabric to the bottom side.
8
