Gilson 1200MP manual TOW Pole Assembly, Saftey Chains

Page 7

TOW POLE ASSEMBLY

The tow pole assembly is located on the front of the mixer and is used for transport only.

For transport, pull the tow pole assembly out, line up the hold and insert the L-shaped pin through holes.

When operating the mixer, pull the L-shaped pin out of the hole and push tow pole assembly all the way in. Line up the holes and insert the L-shaped pin through the holes.

SAFTEY CHAINS

1.Cross chains under the tow pole when connecting the safety hooks to the tow pole. SEE FIGURE 2

2.Allow enough slack to permit vehicle turning while keeping chains snug enough under tow pole to prevent pole from contacting the ground in case of disconnection or hitch failure.

3.Secure safety hooks to appropriate mounting area on tow vehicle.

NOTE: SAFETY CHAIN LENGTH MAY NEED TO BE ALTERED FOR PROPER CONNECTION TO TOW VEHICLE. REPOSITION HOOKS, DO NOT CUT CHAIN.

6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Gilsjn Mixers Gilsjn MixersIntroduction Table of Contents Drum While the Mixer is Running Safety PrecautionsAssembly and PRE-OPERATIONAL Checks Clutch Control Lever Controls and OperationsSaftey Chains TOW Pole AssemblyStarting the Mixer Mixer TransportOperating the Mixer Extension Cords for Electric MotorsLoading the Mixer CleaningTrouble Shooting Guide for MP Mixers Masonry Construction Guidelines Operating GuidelinesWheel Bearings Drum Seal HousingsLubrication Mixing Shaft BearingsJack Shaft Bearings AdjustmentDrum Shaft Bearing Hangers ENGINE/MOTORENGINE/MOTOR Drive StorageSee Figure Page Drum & Drive Page Mixing Blades Page Engine Housing and Axle Page FRAME, Drive and Clutch Control Page Engine and Power Options Additional Power OptionsPage Additional Engine Mount Hardware -SEE REF for Correct Size Model MP1210 Model MP1210 Parts List Exclustion from this Warranty WarrantyHOW to Obtain Parts Service Information
Top Page Image Contents