Gilson 1200MP manual Adjustment, Drum Shaft Bearing Hangers, Engine/Motor, Jack Shaft Bearings

Page 13

DRUM SHAFT BEARING HANGERS

Drum yoke bearing hangers are located on each side of the drum, and are equipped with grease fittings. These bearings should be lubricated once each week with lithium based grade 2 multi-purpose grease.

ENGINE/MOTOR

Refer to the engine/motor operating instructions for all maintenance and lubrication instructions and requirements.

JACK SHAFT BEARINGS

Pillow block style bearing are used on the drive train counter-shaft. See Drum Seal Housing, Lubrication Guidelines for more information. See Figure 4 for bearing locations.

8 – ADJUSTMENT

RUBBER WIPER BLADES

Adjust rubber wipers so they fit snugly against the drum but not to the point that they fold over when the blades rotate.

12

Image 13

Contents Gilsjn Mixers Gilsjn MixersIntroduction Table of Contents Drum While the Mixer is Running Safety PrecautionsAssembly and PRE-OPERATIONAL Checks Clutch Control Lever Controls and OperationsSaftey Chains TOW Pole AssemblyOperating the Mixer Mixer TransportExtension Cords for Electric Motors Starting the MixerLoading the Mixer CleaningTrouble Shooting Guide for MP Mixers Masonry Construction Guidelines Operating GuidelinesLubrication Drum Seal HousingsMixing Shaft Bearings Wheel BearingsDrum Shaft Bearing Hangers AdjustmentENGINE/MOTOR Jack Shaft BearingsENGINE/MOTOR Drive StorageSee Figure Page Drum & Drive Page Mixing Blades Page Engine Housing and Axle Page FRAME, Drive and Clutch Control Page Engine and Power Options Additional Power OptionsPage Additional Engine Mount Hardware -SEE REF for Correct Size Model MP1210 Model MP1210 Parts List Exclustion from this Warranty WarrantyHOW to Obtain Parts Service Information