CD6112
WIRING DIAGRAM
Antenna
Connect the antenna plug from the existing antenna cable (some vehicles require an adaptor).
R (Red)
L (White)
Fuse (15 amp fast blow ATO)
Rear Line out | R (Red) |
Gray | L (White) |
Ground
Connect to ground terminal or clean, unpainted part of chassis.
Memory/Battery
Connect to battery or 12 volt power source that is always live.
The radio will not work if this wire is not connected.
Black
Yellow
Blue
Red
Power Antenna
Connect to power antenna or amplifier. If not used, tape bare end of wire.
Accessory/Ignition
Connect to existing radio wire or radio fuse.
|
| FRONT SP | REAR SP |
|
|
White/Black | White Gray/Black | Gray | Green/Black | Green Purple/Black | Purple |
Stripe | Stripe |
| Stripe | Stripe |
|
Left Speaker | Right Speaker | Left Speaker | Right Speaker |
(Front) | (Front) | (Rear) | (Rear) |
NOTE: The amplifier in this radio is only designed for use with four speakers. Never combine (bridge) outputs for use with two speakers. Never ground negative speaker leads to chassis ground. Failure to wire exactly as shown may cause electrical damage to the radio.
NOTE: Only connect speakers rated in the load impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit.
4
