Jackson TEMPSTAR HH GPX, TEMPSTAR GPX technical manual Troubleshooting, Common Problems

Page 22

SECTION 4: TROUBLESHOOTING

COMMON PROBLEMS

WARNING: Inspection, testing and repair of electrical equipment should be performed only by qualified service per- sonnel. Certain procedures in this section require electrical tests or measurements while power is applied to the machine. Exercise extreme caution at all times. If test points are not easily accessible, disconnect power, attach test equipment and reapply power to test. When replacing electrical parts, disconnect power at source circuit breaker.

Problem: Dishmachine will not fill after the door is close. Power “ON” light is illuminated.

1.Faulty rinse solenoid valve. Repair or replace valve as required.

2.Faulty door switch. Verify the wiring of the switch; if correct, replace the switch.

3.Fouled/faulty high level probe. Clean probe if fouled. If clean, and still not working, replace.

Problem: Dishmachine will not fill after the door is closed. Power “ON” light is not illuminated.

1.Service breaker tripped. Reset. If the breaker trips again, contact an electrician to verify the amp draw of the machine.

2.Machine not connected to power source. Verify that the machine has been properly connected to the power source.

3.Faulty power source. Verify the wiring of the switch; if correct, replace switch.

Problem: Dishmachine will not run after the door is closed. Power “ON” light is illuminated and the unit is filling.

1.Timer motor is faulty. Verify that the timer is rotating. If not, check to see that the motor is receiving power. If so, replace the motor and/or timer assembly.

2.Wash motor faulty/damaged. Verify that the wash motor is getting power. If so, replace the motor.

3.Wash motor contactor faulty. Check for continuity; if contacts are open, replace the contactor.

Problem: (TEMPSTAR GPX) Dishmachine runs continuously in the wash cycle.

1.Machine is in Delime mode. Flip NORMAL/DELIME switch to NORMAL mode.

2.Timer motor is faulty. Verify that the timer is rotating. If not, check to see that the motor is receiving power. If so, replace the motor and/or timer assembly.

3.Cam timer jammed by obstruction. Remove obstruction.

Problem: (TEMPSTAR HH GPX) Dishmachine runs continuously in the wash cycle.

1.Machine is in delime mode. Change Operation Mode from DELIME to NORMAL position.

2.Wash cycle delay timer is faulty. During the wash cycle, the cam timer will move for the first 30 seconds of the wash cycle. The cycle delay timer will then cause the cam timer to stop, in order to increase the length of the wash cycle. The red light on the delay timer is in control of the cam timer. If the red light is not turning on (only during cycles B, C or D), replace the cycle timer.

3.Wash cycle delay timer settings not correctly adjusted. If the wash cycle delay timer and rotating cam timer are working correctly, the time cycles on the delay timer may be incorrectly adjusted. Adjust the delay potentiometer corresponding to the B, C or D cycle. Rerun the appropriate cycle and see if the adjustment has made any change in the length of the cycle. If not, replace the cycle delay timer.

4.Cam timer is faulty. Confirm that the wash cycle delay timer is functioning correctly (see above). Confirm that the timer motor is receiving power. If it is, replace the motor and/or timer assembly. Make sure there are no obstructions which limit the rotation of the cam timer.

Problem: Wash or rinse heater does not work.

1.Faulty heater element. Check element for continuity; if open, replace the heater.

2.Faulty heater contactor. Replace the contactor.

3.Misadjusted/faulty thermostat(s). Verify operation and setting of thermostats, replace if necessary.

Problem: Dishmachine fill slowly and/or the rinse is weak.

1.Clogged or obstructed rinse arms. Remove and clean the rinse arms.

2.Low incoming water pressure. Adjust the water pressure regulator to ensure that there is 20A5 PSI flow.

3.Y-strainer is clogged. Clean out the Y-strainer.

Tempstar/HH GPX Series Technical Manual 7610-002-57-32

Issued: 07-24-2006 Revised: N/A

17

Image 22
Contents Technical Manual August 6 7610-002-57-32 Revision DPage Revision Made Applicable Details Date ECN Tempstar HH GPX Nomenclature for the Models Covered in this ManualTable of Contents Section Specification Information Specification Information Selection C Operating Cycle Seconds Selection aSelection B Selection DSpecification Information Dimensions for Tempstar GPXDimensions for Tempstar HH GPX ALL Dimensions are +/- 1/2 DUE to Adjustable FeetTable Dimensions Section INSTALLATION/OPERATION Instructions INSTALLATION/OPERATION Instructions Installation InstructionsINSTALLATION/OPERATION Instructions INSTALLATION/OPERATION Instructions Dishmachine GAS Booster Heater ConnectionsOperation Instructions INSTALLATION/OPERATION Instructions Section Preventative Maintenance Preventative Maintenance Section Troubleshooting Troubleshooting Common ProblemsProblem Rinse water not reaching required temperature Section Service Procedures Tools Required Service ProceduresPreparation Time RequiredRemove the wire nuts from the wires and separate them Removing the valve bonnet After Maintenance Actions Special PartsVacuum Breaker Repair Parts KIT Preparation StepsRemoving the plunger Section Parts Section Tempstar GPX Control BOX Assembly Parts SectionQTY Description Tempstar HH GPX Control BOX Assembly Bracket, Electrical Box Mounting Tempstar GPX Hood Assembly Item QTY DescriptionTempstar HH GPX Hood Assembly Frame Assemblies TUB Assembly Model Volts Phase Wash Motor Assembly Cantilever ARM/DOOR Assemblies Tempstar GPX Cantilever Arm Cantilever ARM/DOOR Assemblies Tempstar HH GPX Screw, 1/4-20 x 1 1/2 Long Hex Head Inlet Plumbing Assemblies Rinse Header Plumbing Assembly Recirculating Plumbing Assembly Rinse Solenoid Valve & Vacuum Breaker Repair Parts Kits Wash & Rinse ARM/MANIFOLD Assemblies Tempstar GPX 1911Exploded View Wash & Rinse ARM/MANIFOLD Assemblies Tempstar HH GPX Positioning Bracket, Manifold Tube Coil Assembly Parts SectionExhaust FAN Control OPTION/SAFETY Door Interlock SDI Option Tempstar GPX False Panel Installation False panel positioned in unitTempstar HH GPX False Panel Installation Drain Quench Assembly To Cold Water SupplySection Electrical Schematics Electrical Schematics Tempstar GPX 115 Volt 50/60 Hertz Single PhaseTempstar GPX 208-230 Volt 50/60 Hertz Single Phase Tempstar HH GPX 115 Volt 50/60 Hertz Single Phase Tempstar HH GPX 208-230 Volt 50/60 Hertz Single Phase Exhaust FAN Control OPTION/SAFETY Door Interlock SDI Option

TEMPSTAR HH GPX, TEMPSTAR GPX specifications

The Jackson TEMPSTAR GPX and TEMPSTAR HH GPX are two remarkable models in the world of personal watercraft, combining cutting-edge technology with unmatched performance and versatility. Designed to cater to a wide range of riders, these models are engineered for both adventure and leisure on the water.

One of the standout features of the TEMPSTAR GPX is its powerful engine, which delivers impressive acceleration and top speed. The PWC is equipped with a high-performance engine that not only maximizes horsepower but also optimizes fuel efficiency. This balance ensures that riders can enjoy prolonged adventures without the constant need to refuel.

The TEMPSTAR HH GPX, on the other hand, offers enhanced stability and control, making it an excellent choice for beginners and experienced riders alike. This model boasts an extended hull design that improves tracking and maneuverability, allowing for smooth navigation even in choppy water conditions. The innovative hull design also contributes to a more comfortable ride, reducing the impact of waves and enhancing overall stability.

One of the key technologies featured in both models is the advanced onboard digital display. This feature provides riders with real-time data on speed, fuel consumption, and engine performance. Additionally, the intuitive interface allows for easy navigation through menu options, offering a seamless user experience. For those who love to personalize their rides, these models come with customizable settings, allowing riders to adjust various features to suit their preferences.

Safety is a paramount consideration in the design of the TEMPSTAR GPX and TEMPSTAR HH GPX. Both models are equipped with an array of safety features, including a reliable engine shut-off system and a reinforced safety grab handle. Furthermore, the boats comply with rigorous safety standards to ensure peace of mind for riders and passengers.

In terms of comfort, both models come with ample storage space, allowing riders to stow away essentials for a day on the water. Ergonomically designed seating ensures that passengers can relax for hours, while the strategically placed footwells provide additional comfort during long rides.

Overall, the Jackson TEMPSTAR GPX and TEMPSTAR HH GPX embody a perfect blend of power, technology, safety, and comfort. Whether you're looking for thrilling speed on the open water or a leisurely cruise with friends and family, these models offer a reliable and enjoyable riding experience for enthusiasts of all skill levels.