Operation
Microwave-Solo
There is a choice of 9 power settings. The higher the power setting, the more microwaves reach the food.
When heating up food of differing com- position, or which cannot be stirred or turned during cooking, as with a plated meal, it is preferable to heat these on a lower power setting. This ensures that the heat is distributed evenly. Heat for long enough to reach the temperature required.
Times for defrosting, reheating and cooking
The necessary time depends on:
–the initial temperature of the food. Food taken from the refrigerator will need longer to be reheated or cooked than food already at room temperature.
–the type and texture of the food. Fresh vegetables probably contain more water and cook more quickly than stored vegetables.
–the shape and material of the con- tainer.
–the amount of food.
In general:
Double the amount of food - at least one third extra cooking time.
For smaller amounts of food reduce the time accordingly.
Ideally the container should be placed in the middle of the oven.
Press the mtouchpad and use the +/- touchpads to enter the cooking time you require (5 seconds up to 99 minutes).
Press the ütouchpad.
The hsymbol for microwave mode flashes in the display area and P 9 appears.
Use the +/ - touchpads to select the power setting you require.
The hsymbol flashes and the se- lected power setting appears.
Press the START touchpad.
The set time appears in the display area and begins to count down in one second steps.
An audible tone sounds when the cooking time has elapsed.
Press touchpad C to turn off the tone early.
Press the ütouchpad if you want to call up the power setting while the ap- pliance is in operation.
Automatic "Keeping warm"
The automatic "keeping warm" function will switch on for a maximum of 15 minutes after a cooking process using a power setting of 5 or higher has fin- ished.
H:H and the symbol happear in the display area. The turntable continues to operate.
The process is cut short if the door is opened during this time.
The "keeping warm" stage cannot be set separately.
19