Settings J
Water hardness
The dishwasher is equipped with a sensor softener, which automatically detects the hardness of your tap water. After plumbing the dishwasher and finishing a program, e.g. "Rinse & Hold", the water hardness is displayed in the menu "Water hardness".
^Touch OK to go back to "Settings J".
Rinse aid
For best results, the rinse aid dosage can be adjusted.
The dosage can be set in steps from 0 to 6 ml.
The dosage set by default to 3 ml of rinse aid per program.
^Use a higher setting if spots appear on dry glassware.
^Use a lower setting if streaking appears on dishes or glasses.
^Select the desired rinse aid dosage
with the +/- controls and confirm with
OK.
Filter check
This selection allows you to set the number of cycles run before the filter check message shows.
You can select between 30 and 60 cycles.
The filter check message is set by default to 40 cycles.
^Select the desired interval and confirm with OK.
Adjust Sensor Wash
The "Sensor Wash" program can be adjusted to clean stubborn but normal soiling.
^Select Yes to activate this function and confirm with OK.
44