Building in the appliance
Building in the appliance
^ Remove cover a. |
^ Secure bracket b with screws c |
(4.8 x 16 mm). |
^Push the appliance into the
Take care not to trap the mains cable.
^Push in the appliance until the front edges of bracket b and hinge plates d and e are flush with the front edge of the housing.
^Align the appliance height from above on both sides using adjusting screw f.
^Plug the gap between the appliance and the furniture wall on the door opening side with sealing strip g. Press the sealing strip into the gap starting at the bottom, and cut to length so that it fits snugly to the lower edge of bracket b.
36