Location, Assembly, Electrical Connections

LOCATION

The area around the broiler should be kept free and clear of all combustible materials.

ASSEMBLY

Mount the broiler to the range (the two broiler legs slide in and are mounted to the two channels provided in the back of the range).

ELECTRICAL CONNECTIONS

WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL CODES.

WARNING: DISCONNECT THE ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT SWITCH TO INDICATE THAT YOU ARE WORKING ON THE CIRCUIT.

VB73 and VB73R Broilers

Bring the broiler leads (A1, A2, B1, B2 in 208, 240 and 480 volt models, and X, Y, N in 220/380 or 240/415 volt models) down and through the range's burner box compartment to the circuit breakers or the terminal block and connect them to the proper terminal. Refer to the wiring diagram of the range (located on the kick panel), or the schematic decal on the broiler.

ESB36 Broiler

Bring the broiler leads (A1, A2, B1, B2 in 208, 240 and 480 volt models, and X, Y, N in 220/380 or 240/415 volt models) down through the wire chase located on the rear of the range, and connect the terminal as required to the electrical supply. It may be necessary to remove the 1/4-20 screw that retains the wire chase to the range in order to properly feed the wires through the chase. Refer to the wiring diagram of the range (located on the kick panel), or the schematic decal on the broiler.

VB73, VB73R and ESB36 Broilers

Broilers wired for 3-phase service may be changed to 1-phase (or vice versa) by simply relocating two of the four broiler leads on the range's terminal block as shown in the wiring diagram of the particular range to which the salamander broiler is mounted.

All required broiler wiring diagrams are packaged separately in a clear plastic ziplock bag and shipped with the broiler.

— 5 —