Sears 45520 To SET SELF-CLEAN Cycle, To Interrupt a Clean Cycle, When a Clean Cycle is Finished

TO SET SELF-CLEAN CYCLE:

1.Close oven door. Push CLEAN. The time display will show (---). See Fig. 1. You may need to press slightly on the door.

TO INTERRUPT A CLEAN CYCLE:

1.Push CLEAR/OFF.

Follow Instructions under "WHEN A CLEAN

CYCLE IS FINISHED."

Fig. 1

2.Press L_ or L_ to set the desired length of clean time. Clean time is normally 3 hours. YOU can change it between 2 and 4 hours, depending on how

dirty the oven Is. See Fig. 2. The door locks automatically after the controls are set. The display will show "LOCK" when door locks.

Fig. 2

YOU can push STOP TIME to find OUt when the cycle will end. Push CLEAN to return to countdown.

WHEN A CLEAN CYCLE IS

FINISHED:

1.Walt until the LOCK display goes out. The oven temperature muSt drop to a safe level before the door can be opened. See Fig. 3.

WAIT UNTIL LOCK GOES OUT

Fig. 3

If you cannot open the door immediately after the word LOCK goes off, walt about one minute and try again.

TO SET DELAYED SELF-CLEAN CYCLE:

Follow steps 1-2 under "TO SET SELF.CLEAN

CYCLE," THEN:

3.Press STOP TIME.

4.Set the time of day when you want the clean cycle to end. See Fig, 4.

The control will calculate the start clean time.

Fig. 4

Note: When selecting a stop time for a delayed clean cycle, you must allow time for the 2-4 hour clean time.

Your oven light should be OFF during a self-clean cycle to prolong the life of the bulb.

14 NESCL07-1