Connect the Ice and Water'
System to Cold Water
Supply.
Refer to the instructions on the back of the cabinet.
Pilacement and Leveling
i,i i I,IIH
, CAUTION:
To avoid cross threading and water ieaks, you must start alt the water tube fittings several turns by hand before tightening with wrenches. DO NOT OVER- TIGHTEN. Also be sure to double check for water leaks after turning on the water pressure to the refrigerator.
Placement
On some counter tops there is a 1"
overhang If this is the case, the front corners of the counter top must be trimmed off at a 45 ° angle for the refrig- erator and freezer door clearance (see Figure 15) To build in your refrigerator a Perimeter Trim Kit is available at an additional cost.
A recessed electrical outlet installedon the back kitchen wall atfows for a
To build in your refrigerator with other options, such as wood or laminate con- sult with a local kitchen designer.
Units have front wheets that can be adjusted by turning a screw as shown in Figure 16.
CAUTION
To Avoid Property Damage to soft vinyl floodng follow the floor prod-
uct manufacturer's recommenda-
).......... ,,!,.............ll!,I tions when installingor moving
the refrigerator.
If the floor is uneven from side to side,
place thin metal plates under one of the rear wheels.
FIGURE 15
Leveling
Installthe unit on a solid floor that is strong enough to support the combined weight of the unit, approximately 320 tbs.; and the food, maximum of 625 ibs
with an approximate combined weight of 945 tbs.
POWER SWITCH
Located behind the toe grille in the cen- ter is a switch. This switch must be in
the on position before you proceed any further.
SWITCH
]'heunit must be level to insure corn- plete door closingsand proper ice mak- ing. Improper leveling will cause water spills and uneven ice cube size.