Tool List, Additional Materials, Location

INSTALLATION

IMPORTANT: Leave these instructions

with the appliance.

TOOL LIST

The following tools are needed to Install your new counter unit.

Pipe wrenches

Flat bladed screwdriver

•Rule or tape measure and straightedge

•Hand saw or saber saw

ADDITIONAL MATERIALS

•Gas supply line shut-off valve

•Pipe joint sealant (resistant to L.P. gas)

OWNER: Keep these instructions for future use.

LOCATION

See Figures 1 and 2 and Table 1 for all rough-In and spacing dimensions. These dimensions must be met for safe use of your counter unit. See Fig. 3 for recom- mended location of gas supply line. Do not Install the unit near an outside door or where a draft may affect Its use.

MINIMUM CLEARANCES TO BE MAINTAINED:

1-3/4" between cutout rear edge and wall behind unit.

3-1/4" between cutout front edge and counter front

edge.

30" between cooktop and nearest overhead surface.

3" on the right and on the left side of the cutout to a height of 18".

30" MIN.	I
TO CABINET	3" MIN.
	CLEARANCE	18" MIN. I"
J	TO SIDE WALL .TO CABINET

CLEARANCE _

I I

CUTOUT AND COUNTER UNIT DIMENSIONS		Fig. 1
TABLE	1
DIMENSIONS
A	30 1/4"
B	21 1/4"
C	28-3/8"
D	19-3/8"
E	19-1/2"
F	28-1/2"
G	14-1/4"
H	3"
J	1-3/4"
K	3-1/4"

" '

Fig. 2

MINIMUM CLEARANCES TO

ADJACENT CONSTRUCTION

IMPORTANT:

Reaching over surface burners can cause fire or burns. You should not use storage space above the cooktop. If you choose to use cabinets above the cooktop, install a range hood that sticks out at least 5" beyond the front of the cabinets. Cabinets Installed above a cooktop may benD deeperthan 13".

NGINS18