Setting Warmer Drawer Controls
| Removing | and | Replacing | Warmer Drawer (If equipped) | |
| Pullup with | To Remove and Replace Warmer (Warm & Ready TM) Drawer | |||
[] | To Remove Warmer Drawer: | ||||
| |||||
|
| 1. | _ | Turn power off before removing the warmer drawer. |
2.Open the drawer to the fully opened position.
3.On the right glide you will find a shield attached with a
4.Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever.
5.Pull the drawer away from the range.
Removeshieldon rigl glide. Pullup on left le_er while pushingdowno_
Pu=hdown with fli'_er
Figure I
To Replace Warmer Drawer:
1.Replace shield on the right glide of the drawer body.
2.Pull the bearing glides to the front of the chassis glide (see figure 2).
3.Align the glide on each side of the drawer with the glide slots on the range.
4.Push the drawer intothe range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hearthe
levers "click" or the bearing glides do not feel seated remove the drawer _,,C_ and repeat steps
glides.
NOTE: The Warmer Drawer wi!!NOT operate while inthe
serious injury or death. Disconnect appliance from electric power before cleaning Electricaland servicingShocktheHazardwarmercandraweroccur. and result in
Figure 2
15