Maytag SS-2 warranty Nondispenser Models, Dispenser Models, For Your Safety

Ice Service ...........

Nondispenser Models

To check the ice level or gain access to the ice bin, lift

The freezer compartment of your refrigerator is equipped with ice cube trays and an ice storage bin. The bin is designed to stack neatly on top of the stacked ice cube trays. To release the ice cubes from a tray, hold the tray upside down over the bin and twist both ends.

Your refrigerator is automatic ice maker ready. The number for the ice maker kit you need appears on the

data plate (see page 1).

open the door on the ice bin.

To remove the bin, first turn off the ice maker. This is done by opening the door on the ice bin and moving the ice maker wire lever up to the "off' position. Then reach under the bin front and pull down on the back edge. After it snaps free, pull the bin straight forward. To replace the ice bin, align the bottom rails to the corresponding shelf grooves and push it straight back until it stops and latches. Make sure the tabs, at the back of the bin, that turn the spiral auger are positioned between the prongs from the auger motor. Turn the ice maker on by low- ering the wire arm.

Beverages and foods should not be placed in the ice storage bin for quick chilling. These items can block the wire lever arm, causing the ice maker to malfunction.

Dispenser Models

Automatic Ice Maker

After your refrigerator has been connected to the water supply, move the wire lever arm into the down position. This will start its operation. The ice maker will fill with water when the freezer reaches the proper temperature. It may be 8 to 12 hours before the ice maker furnishes any usable ice cubes.

Discard all the cubes from the first two or three batches made. These initial ice cubes may be irregularly shaped, discolored, or contain impurities from the new water supply piping.

When the ice cubes are ejected it is normal for several cubes to be joined together at the ends. They can easily be broken apart. The ice maker will continue to make ice until the supply of ice cubes raises the wire lever arm, shutting the ice maker oft.

To manually stop the operation of the ice maker, move the wire lever arm into the up position.

Certain sounds may accompany the various cycles of the ice maker,

•buzzing of the water valve

•running of the water as the tray fills

•rattling of the ice cubes falling into an empty ice bin.

If the ice is not used frequently, the ice cubes will become cloudy, shrink, stick together and taste stale. Empty the ice storage bin periodically and wash it in lukewarm

water. Be sure to dry the bin before replacing it or the ice cubes will stick to the metal auger.

For Your Safety

Do not place tln g ers or hands on the automatic ice making mechanism while the refrigerator is plugged in. This will help protect you from possible injury. It will also preven{ interference with moving parts of the

ejector mechanism and the heating element that releases the cubes.

Under certain rare circumstances ice cubes may be

diseolored, usuatly appearing with a green-bluish ime, The cailse of this unusual discoloration is apparently a combination of factors such as certain characteristics of

local waters, household plumbing and the aceumula-

tion of copper salts in an inactive water supply line whieh feeds the ice maker.

Continued consumption of such discolored ice cubes may be injurious to health If such discoloration is observed, discard the ice eubes and contaet your dealer from whom the refrigerator was purchased.

14