Presetting the Radio Stations

You can preset 50 stations for AM (MW) and FM. Before tuning, make sure that you have turned down the volume.

1.Press AM/FM on the remote control until AM (MW) or FM appears in the display window.

2.And then every time you press AM/FM, AM (MW) or FM changes alternately.

3.Press and hold TUNE - or + on the remote control or TUNING - or + on the front panel for about two seconds until the frequency indication starts to change, then release.

Scanning stops when the DVD Home Theater System tunes in a station. “TUNED” and “ST.” (for stereo program) appear in the display window.

4.Press PROG on the remote control.

A preset number will flash in the display window.

5.Press PRESET v or V on the remote control to select the preset number you want.

6.Press PROG on the remote control again.

The station is stored.

7.Repeat steps 3 to 6 to store other stations.

To tune in a station with a weak signal

Press TUNE - or + repeatedly in step 3 to tune in the station manually.

To clear all the stored stations

Press and hold PROG for about two seconds and “CLEAR ALL” is appeared in the display window and then press PROG again, the stations are cleared.

If you have accidentally entered into the "CLEAR ALL" mode and you do not wish to clear the memory, do not press any key. After a few seconds, the "CLEAR ALL" display will go off by itself and change to normal mode.

Note:

If all stations have already been entered, the FULL message will appear in the display window for a moment and then a preset number will flash.

To change the preset number, follow the steps 5-6 as above.

Listening to the Radio

Preset radio stations in the DVD Home Theater System’s memory first (see “Presetting radio stations” on the left).

1.Press AM/FM until AM (MW) or FM appears in the display window.

The last received station is tuned in.

2.Press v or V repeatedly on the remote control to select the preset station you want.

Each time you press the button, the DVD Home Theater System tunes in one preset station at a time.

3.Adjust the volume by rotating VOLUME on the front panel or by pressing VOLUME + or - on the remote control repeatedly.

To turn off the radio

Press POWER to turn the DVD Home Theater System off or select another function mode (DVD/CD, AV 1, etc.,).

To listen to non-preset radio stations

Use manual or automatic tuning in step 2.

For manual tuning, press TUNE - or + on the remote control repeatedly.

For automatic tuning, press and hold TUNE - or + on the remote control for about two seconds on the front panel.

To select a preset radio station directly

You can use the number buttons on the remote control to select a preset radio station directly.

For example, to listen to preset station 4, press 4 on the remote control. To listen to preset station 19, press 1 then 9 (within 3 seconds).

For your reference

If an FM program is noisy

Press MONO/STEREO on the front panel so that “STEREO” disappears in the display window. There will be no stereo effect, but the reception will improve. Press MONO/STEREO on the front panel again to restore the stereo effect.

To improve reception

Reorient the supplied antennas.

title

Operation