QUESTIONS? USE this Problem Solver, Possible Cause

B ‘1 and Oven Burner Air Adjustment Shutters

Air adjustment shutters for the broil and oven burners regulate the flow of air to the flame.

All ovens are factory adjusted for use with the natural gas used in most areas. But, since the gas in some areas may be different, you should check all adjustments described. If you are using LP gas, all the adjustments must be made.

To adjust the flow of air to either burner, loosen the Phillips head screw and rotate the shutter to allow more or less air into the burner tube as needed.

The flames for the top (broil) burner should burn steady with approximately 1“ blue cones and

The air adjustment shutter for the top burner is in the center of the rear wall of the oven.

The shutter for the bottom burner is near the back wall. Remove the oven bottom for access.

7)~ Loosen

Air adjustment shutter

-:---”-’- \<

p-. p

should not extend out over the edges of the burner baffle.

To determine if the bottom burner flames are proper, remove the oven bottom and the burner baffle. The

Turn the burner full on				%,.
and check the flames.		Loosen		!
The burner tlames should
			,“
not flutter or blow away			4*
from the burner. They			““Airadjustment’		~
should be blue in color				“

with no trace of yellow.				‘>\4
Foreign particles in the		/“		<./	.,

gas line may cause an				*0,’)
				‘L.,
or;	~ flame at first, but	/“		+
this will soon disappear.				<..,
				~...
If the flames are yellow		\		“’n”>.../“

or flutter, open the air shutter more. If they blow away from the burner, close the air shutter more.

See the illustration in the Problem Solver of this guide for correct tlame appearance.

flames should have 1/2” to 3/4” blue cones with no yellow tipping. When the baffle is back

in place, the flames will resettle.

Visually check the color of the flames every

6 months. If they look like illustration (A) on the Problem Solver in this guide, call for service.

QUESTIONS?

USE THIS PROBLEM SOLVER

PROBLEM

“F-” AND A NUMBER FLASH IN THE DISPLAY

FOOD DOES NOT

BROIL PROPERLY

—

POSSIBLE CAUSE

●If the time display flashes “F-” and a number, you have a function error code. Press the CLEAIUOFF pad. AI1ow the oven to cool for one hour. Put oven back into operation. If the function error code repeats, disconnect all power to the oven. CaIl for service.

●The oven controls are not properly set. See the Broiling section.

●Improper shelf position being used.

●Food is being cooked on a hot pan.

●Cookware is not suited for broiling.

●Door is open.

●Aluminum foil used on the broiler pan rack has not been fitted properly and slit as recommended.

(continued next page)