www.GEAppliances.com
The oven door must be closed and all controls must be set correctly for the cycle to work properly.
Safety
How to Delay the Start of Cleaning
Press the SELF CLEAN STD/LOW pad once for a
A
If a time other than 4 hours or
3 hours is needed, use the HOUR and MIN + or – pads and enter the desired clean time.
You can change the clean time to any time between 3 hours and 5 hours, depending on how dirty your oven is.
Press the DELAY START pad.
Using the HOUR and MIN + or – pads, enter the time of day you want the clean cycle to start.
Press the START pad.
The door locks automatically. The display will show the start time. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCKED light goes off.
When the LOCKED light goes off, you will be able to open the door.
NOTE: On models with touch pad controls for both ovens, you can set a delay clean in both ovens at the same time. The second oven set will automatically delay the start of cleaning until the end of the first oven’s clean cycle.
To recall the start time of the second oven set, press the DELAY START pad on the controls for the second oven.
Instructions Operating Instructions Care and
After a Clean Cycle
You may notice some white ash in the oven. Wipe it up with a damp cloth after the oven cools.
If white spots remain, remove them with a
These deposits are usually a salt residue that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle, repeat the cycle.
■You cannot set the oven for cooking until the oven is cool enough for the door to unlock.
■If the shelves become hard to slide, wipe the shelf supports with cooking oil.
Cleaning Troubleshooting Tips Consumer Support
17