Instructions
Care and cleaning of the oven.
Be sure electrical power is off and all surfaces are cool before cleaning any part of the oven.
Safety
How to Remove Packaging Tape
To assure no damage is done to the finish of the product, the safest way to remove the adhesive left from packaging tape on new appliances is an application of a household liquid dishwashing detergent, mineral oil or cooking oil.
Apply with a soft cloth and allow to soak. Wipe dry and then apply an appliance polish to thoroughly clean and protect the surface.
NOTE: The plastic tape must be removed from all chrome trim. It cannot be removed if it is baked on.
Operating Instructions
Control Panel
It’s a good idea to wipe the control | Do not use abrasive cleansers, strong |
panel after each use. Clean with mild | liquid cleansers, plastic scouring pads or |
soap and water or vinegar and water, | oven cleaners on the control |
rinse with clean water and polish dry | will damage the finish. A 50/50 solution |
with a soft cloth. | of vinegar and hot water works well. |
and Cleaning
Molded rib
Spring clip
Clear groove in stem
Knob (on some models)
The control knob (lower oven only) may be removed for easier cleaning.
Before removing the knob for cleaning, please note that the knob is in the OFF position. When replacing the knob, check the OFF position to insure proper placement.
Wash the knob in soap and water or a vinegar and hot water solution but do not soak.
The knob stem is D shaped. Install the flat of the shaft to the flat of the knob.
Consumer Support Troubleshooting Tips Care
Slot
Hinge lock
Pull hinge locks down to unlock
Removal position
18
Lift-Off Oven Door
The door is very heavy. Be careful when removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Pull the hinge locks down toward the door frame, to the unlocked position. A tool, such as a small
Firmly grasp both sides of the door at the top.
Close door to the door removal position, which is halfway between the broil stop position and fully closed.
Lift door up and out until the hinge arm is clear of the slot.
To replace the door:
Firmly grasp both sides of the door at the top.
With the | Bottom | Hinge arm |
door at the | edge |
|
same angle as | of slot |
|
the removal |
|
|
position, seat the |
| |
indentation of |
| Indentation |
the hinge arm |
| |
|
| |
into the bottom |
| |
edge of the hinge |
| |
slot. The notch in the hinge arm | ||
must be fully seated into the bottom | ||
of the slot. |
|
|
Fully open the door. If the door will not fully open, the indentation is not seated correctly in the bottom edge of the slot.
Push the hinge locks up against the front frame of the oven cavity, to the locked position.
Hinge arm
Hinge lock
Push hinge locks up to lock
Close the oven door.