cleaning
Automatic clean function
The coffee maker is equipped with an automatic clean function. After 60 brewing cycles, the clean 
indicator/button (21) lights up. This indicates that the coffee maker should be cleaned using the automatic clean function and the charcoal filter (16) should be replaced.
NOTE: The coffee maker can continue to be used, when clean 
indicator/button (21) is on.
•To begin the cleaning cycle, remove the charcoal filter (16) from the water tank (9). Fill the tank with a vinegar and water mixture (½ vinegar and ½ water) or a descaling product.
•Press and hold clean 
button (21) for 2 seconds to start program. The coffee maker beeps once before cleaning starts. The clean
button (21) flashes while the program is running.
•Press and hold the clean 
button (21) for 3 seconds to stop program once it has started.
•Press 
button (29) anytime during clean cycle to stop program and allow the unit to start to brew.
•After completion of cleaning program or if power is lost during clean cycle, the counter is reset, and the clean 
button light (21) will go out.
Cleaning process:
•Continuous cycles of 7 seconds brewing and 21 seconds off until tank is empty.
•After cleaning process is complete the clean 
indicator/button (21) goes off. Fill water tank (9) with clean water and run one brewing cycle to rinse the coffee maker.
•Change the charcoal filter (16) (ill. k ). Reinsert the charcoal filter into the coffee maker (ill. l ).
NOTE: You can use the cleaning function before reaching 60 cycles by following the steps above (especially if the water hardness in your area is above normal).
NOTE: Replacement water charcoal filters and carafes are available at
14