Control Module
Removal
1.Remove the outer door panel (see Door Compo- nents).
2.Open the door and remove the 3 screws from the back on the right side of the escutcheon keypad assembly.
3.Remove 1 screw from the right side of the control module and slide the module out.
4.Unplug the connectors from the module. Installation
Note: The gray cable is a factory test cable (see photo) and may be removed when servicing control module.
1.Plug connectors into control module.
2.Insert the tabs on the left side of the control module into the slots on the inner door panel and secure the module with 1 screw.
3.Install 3 screws on the right side of the escutch- eon and replace the outer door panel (see Door Components).
Detergent/Rinse Module
The door panel must be removed to access the detergent/rinse module. Refer to the Door Compo- nent section.
The detergent/rinse module can be activated using service mode. Refer to the Service Mode chapter.
The detergent/rinse module automatically dis- penses both the detergent and the rinse agent at the appropriate times. The module is activated 2 times during a wash cycle.
The first time the module is activated (1), the lever slides up the
2 Tabs | 1 Screw |
P0003697
Factory
Test Cable
Cover | Main |
| wash |
| section |
Cover
Rinse agent adjuster
Indicator |
|
window | Dispenser cap |
1 2 3
L1 Voltage from |
|
|
| |
|
| DOOR |
| |
| DETERGENT MODULE | INTERLOCK |
| |
RY | WR | WX | N | |
| NO | COM | ||
|
| |||
|
|
|
|
– 14 –