Review
1.The incoming water temperature must be
_________.
2.The dishwasher has a ______ year parts warranty.
The electronic module has a _____ year
_________________ warranty.
3.The dishwasher has a ______ year labor warranty.
4.If the bearing washer (item #611) on the top rack, bottom wash arm is left out, then:
a.washability can be affected.
b.glassware can be broken.
c.excessive wear will occur.
d.all of the above will occur.
e.none of the above will occur, the part is really not needed.
5.Circle the button(s) which must be pushed to enter Service Mode.
FLAT PANEL
5L 4L 3L 2L 1L | START | 1R 2R 3R 4R |
RESET |
Indicates Keypad Used Only on Some Models
BOWED PANEL
5L | 3L | 2L | 1L | 4L | START | 1R | 2R | 3R | 4R |
|
| RESET |
|
|
|
Indicates Keypad Used Only on Some Models
6.The high drain loop, mounted on the side of the tub, can be removed if needed.
T or F
7.A blinking START/RESET keypad light indicates:
a.Sequence switch problem.
b.Cycle was interrupted and dishwasher will drain and stop.
c.There is a problem with the heater circuit.
d.There is a problem with the water valve circuit.
8.A blinking Clean light indicates:
a.The unit has no water.
b.There is a problem with the turbidity sensor circuit.
c.The water was not heated properly on sani- cycle models.
d.Dishwasher is in Extended Wash Mode.
9.The detergent/rinse agent dispenser is activated with _____ volts ____ times during the cycle.
10.If the turbidity sensor fails, the dishwasher stops, beeps, drains, and terminates the cycle.
T or F
– 38 –