Safety Information
Operating Instructions
Troubleshooting Tips
Customer Service
About the dishwasher control panel.
| 3 | Options |
|
| The light above the selected pad will be ON to indicate which OPTION has been selected. | ||
|
|
|
|
|
| POWER | For use with heavily soiled and/or |
|
| PRESOAK | selected PRIOR to starting the cycle. This option adds 16 minutes to the |
|
|
| cycle time. |
|
|
|
|
|
| SPEED DRY | Shuts off the drying heat option. Dishes air dry naturally and energy is saved. You |
|
| OFF | can prop the door open after the CLEAN light illuminates. |
|
|
|
|
|
| SPEED DRY | Turns the heater on for fast drying. This cycle will extend the time to your wash |
|
| ON | cycle by 23 minutes for the NORMAL cycle and 30 minutes for the SANI WASH |
|
|
| cycle. NOTE: Cannot be selected with RINSE ONLY cycle. |
|
|
|
|
|
| LOCK | When the LOCK pad is touched twice within 3 seconds, all pads become inoperative. |
|
|
| You can lock the controls to prevent any selections from being made. Or you can lock the |
|
|
| controls after you have started a cycle or selected DELAY START so the cycle or DELAY |
|
|
| START is not interrupted. |
|
|
| Children cannot accidentally start dishwasher by touching pads with this |
|
|
| option selected. |
|
|
| To unlock the dishwasher after it has been locked, touch the LOCK pad twice within |
|
|
| 3 seconds. The light above the LOCK pad will turn off. |
|
|
|
|
|
| DELAY START | You can delay the start of a wash cycle for up to 8 hours. Press the DELAY START |
|
|
| pad to choose the number of hours you want to delay the start of the cycle. The |
|
|
| machine will count down and start automatically at the correct time. Pressing the |
|
|
| START/RESET button will cancel the DELAY START selection. |
|
|
| NOTE: If you forget to latch the door a reminder signal will beep until you do so. |
|
|
|
|
|
| RESET | To change a cycle after washing starts, touch the START/RESET pad to cancel |
|
|
| the cycle. After water is pumped out and the motor stops, you can reprogram |
|
|
| and restart the dishwasher. This will take approximately 90 seconds. |
|
| Start |
|
| 4 |
| |
|
| Close and latch the door. Touch the START/RESET pad to begin the cycle. Water | |
|
| fill begins, and approximately 40 seconds later the wash action begins. | |
|
| NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram | |
|
| each time. When the dishwasher is loaded and the door latch is in the locked | |
|
| position, the control panel lights will be ON and display the last settings you | |
|
| selected. |
|
|
| If you don’t want to change any of the settings, simply touch the START/RESET | |
|
| pad to begin the cycle. | |
|
| Also, if a power failure occurs, NORMAL and SPEED DRY will automatically be | |
|
| programmed. Make any new selections and touch the START/RESET pad to begin | |
|
| the cycle. |
|
|
| Clean |
|
| 5 |
| |
|
| This light is illuminated when a wash cycle is complete. The light will stay ON | |
|
| until the door is opened. | |
10