GE GSD5930, GSDL352 Dishes don’t dry, Select Speed DRY, Control panel, Responded to inputs, Steam

Problem	Possible Causes	What To Do
Dishes don’t dry	Low inlet water	• Make sure inlet water
	temperature	temperature is correct
		(see page 12).
		• Select SPEED DRY.
	Rinse agent dispenser	• Check the rinse agent
	is empty	dispenser.
Control panel	Door latch may not be	• Call for service.
responded to inputs	properly seated
but dishwasher never
filled with water
Dishwasher won’t run	Fuse is blown, or the	• Replace fuse or reset
	circuit breaker tripped	circuit breaker. Remove
		any other appliances from
		the circuit.
		• Try resetting the
		START/RESET pad.
Steam	This is normal	• Steam comes through
		the vent by the door latch
		during drying and when
		water is being pumped out.
Sanitized light does	The door was opened	• Do not interrupt the cycle
not illuminate at the	and the cycle was	anytime during or after
end of the cycle	interrupted during or	main wash.
	after the main wash
	portion
	The incoming water	• Raise the water heater
	temperature was too low	temperature to 120°F.

Safety Information

Operating Instructions

Troubleshooting Tips

Customer Service

23