GE GSD5950, GSDL352, GSDL322, GSDL332, GSD5920, GSD5910, GSD5940 Dishes and flatware, Not clean

Problem	Possible Causes	What To Do
Dishes and flatware	Low inlet water	• Make sure inlet water
not clean	temperature	temperature is correct
		(see page 12).
	Water pressure is	• Turn on a faucet. Is water
	temporarily low	coming out more slowly
		than usual? If so, wait until
		pressure is normal before
		using your dishwasher.
	Air gap is clogged	• Clean the air gap.
	Improper rack loading	• Make sure large dishware
		does not block the
		detergent dispenser or the
		wash arms.

Safety Information

Operating

Spots and filming on glasses and flatware

Extremely hard water

Low inlet water temperature

Overloading the dishwasher

Improper loading

Old or damp powder detergent

Rinse agent dispenser empty

Too little detergent

•Use Jet-Dry®rinse agent to remove spots and prevent new film buildup.

•To remove stubborn spots and pre-existing film from glassware:

1Remove all metal utensils from the dishwasher.

2Do not add detergent.

3Select the longest cycle.

4Start the dishwasher and allow to run for 18 to 22 minutes. Dishwasher will nowbeinthemainwash.

5Open the door and pour 2 cups (500 ml) of white vinegar into the bottom of the dishwasher.

6Close the door and allow to complete the cycle.

If vinegar rinse doesn’t work: Repeat as above, except use 1/4 cup (60 ml) of citric acid crystals instead of vinegar.

Instructions

Troubleshooting Tips

Customer Service

21