GE GSD500 manual For Light Wash cycle Be sure door is unlatched

How to operate your dishwasher

STEP 1. Load your dishwasher with dishes, silverware, pots, pans, bowls, etc. according to instructions on pages 8 and 9.

STEP 2. Add detergent to the detergent dispenser. Make sure the Cycle Indicator Dial is at OFF position before adding detergent. (See pages 6 and 7.)

Use rinse aid agent to help prevent spotting. (See page 6.) - -

STEP 3. Select

Option.

)

HEATED

DRYING

NO HEAT

DRYING

HEATED DRYING. Turns the drying heater on for fast drying.

ENERGY SAVER (no heat

drying). Turns the drying heater off to save energy. Dishes will dry naturally over a longer period such as overnight.

If you need your dishes sooner, open the dishwasher door after the cycle is complete to reduce the natural drying time.

Use of this option reduces the electrical energy used by this model approximately 79?0 for the NORMAL WASH cycle.

STEP 4. Select the Cycle and start dishwasher.

If your dishwasher drains into a , food waste disposer, operate the disposer until it is empty before starting the dishwasher. (See Cycle selection hints on next page.)

To obtain the benefits of a complete cycle, be careful that you

do not turn the dial any further than necessary to start the dishwasher.

c For NORMAL WASH cycle:

a. Latch the door.

s

RINSE & HOLO uJ=”$’op~loM~

b. Slowly turn Cycle Indicator Dial to ON position to start the cycle. You will hear the motor start. There is a time delay between start-up and water fill so you will not hear any wash action right away.

●For LIGHT WASH cycle:

a. Be sure door is unlatched.

0~.ON E.IGMT

WASH

●

0

ORVING ●

@

m

RINSE & HOW Iu$~ Wn$WTIJprlONI

b. Slowly turn Cycle Indicator Dial to LIGHT WASH position.

c. Latch door to start the cycle. ‘ -

●For RINSE & HOLD cycle:

a. Be sure door is unlatched.

b. Select ENERGY SAVER drying option.

c. Slowly turn Cycle Indicator Dial to RINSE & HOLD position.

d. Latch door to start the cycle.

4