GE 165D4700P227 owner manual Options, Start, Clean

2	Options
	The light above the selected pad will be ON to indicate which OPTION has been selected.
	HI TEMP	Turns on the heater in all postrinse and final rinse cycles to help prevent spotting
	RINSE	on dishware. This option may be turned ON or OFF during the wash cycle.
	HI TEMP	Energizes the heater to boost water temperature in all prewash and main wash fill
	WASH	cycles. Recommended for use with heavily soiled dishes. Option may be turned ON
		or OFF during the wash cycle.
	HEATED DRY	Shuts off the drying heat option. Dishes air dry naturally and energy is saved. You
	OFF	can prop the door open after the CLEAN light illuminates.
	HEATED DRY	Turns the heater on for fast drying. This cycle will extend the time to your wash
	ON	cycle by 30 minutes. NOTE: Cannot be selected with RINSE ONLY cycle.
	LOCK	When the LOCK pad is touched twice within 3 seconds, all pads become inoperative.
		You can lock the controls to prevent any selections from being made. Or you can lock the
		controls after you have started a cycle or selected DELAY START so the cycle or DELAY
		START is not interrupted.
		Children cannot accidentally start dishwasher by touching pads with this
		option selected.
		To unlock the dishwasher after it has been locked, touch the LOCK pad twice within
		3 seconds. The light above the LOCK pad will turn off.
	DELAY START	You can delay the start of a wash cycle for up to 8 hours. Press the DELAY START
		pad to choose the number of hours you want to delay the start of the cycle. The
		machine will count down and start automatically at the correct time. Pressing the
		START/RESET button will cancel the DELAY START selection.
		NOTE: If you forget to latch the door a reminder signal will beep until you do so.
	RESET	To change a cycle after washing starts, touch the START/RESET pad to cancel
		the cycle. After water is pumped out and the motor stops, you can reprogram and
		restart the dishwasher. This will take approximately 90 seconds.
	Start
3
	Close and latch the door. Touch the START/RESET pad to begin the cycle. Water
	fill begins and approximately 40 seconds later the wash action begins.
	NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram
	each time. When the dishwasher is loaded and the door latch is in the locked
	position, the control panel lights will be ON and display the last settings you
	selected.
	If you don’t want to change any of the settings, simply touch the START/RESET
	pad to begin the cycle.
	Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be
	programmed. Make any new selections and touch the START/RESET pad to begin
	the cycle.

4 Clean

This light is illuminated when a wash cycle is complete. The light will stay ON until the door is opened.

Safety Information

Operating Instructions

Troubleshooting Tips

Customer Service

9