Samsung DE7711 manual Safety Requirements for Installation, Electrical Wiring

Page 47

MICROWAVE OVEN INSTALLATION REQUIREMENTS

Safety Requirements for Installation:

Electrical Wiring

The operating voltage should comply with the voltage specified in the label of the microwave oven type attached to the back of the appliance.

WARNING

This appliance is equipped with a capacitor. To remove or relocate the appliance, take the battery out and wait for about 20 seconds, and then disconnect the power cable connections. If the power cable is disconnected too soon, it may cause an electrical short circuit and discharge (spark).

The operating voltage should comply with the voltage specified in the microwave oven type label on the back of the appliance.

It is a good idea to install an additional safety fuse to a positive(+) power cable. If the connection power cable is damaged or causes a short circuit,

it means that the safety fuse can no longer prevent the appliance from being damaged (cable fire). The safety fuse should be installed as close to the battery as possible.

If the electrical cabling is not performed properly, it may cause an electrical short circuit, resulting in the following:

•Power cable may catch fire.

•Airbag may burst.

•Controller may work improperly.

•An electrical component may malfunction. (Signal lamp, Brake lamp, Horn, Ignition, Lighting, etc.).

To eliminate the danger of an electrical short circuit, always disconnect and isolate the battery negative terminal before using an electrical device in the vehicle. Also, in the case of a vehicle equipped with an additional battery, disconnect and isolate the negative(-) battery power cable.

Precaution

When disconnecting and isolating the negative battery power cable, all the data stored in the memory of the vehicle's system will disappear.

Depending on equipment included in your vehicle, you may have to enter the following data again: Ex) Vehicle audio password, vehicle clock, seat location, panel computer, and time switch.

Connection Power Cable

•Do not pull the power cable forcibly.

•Do not connect to a power supply other than 12V.

•Comply with the minimum diameter of the power cable as specified in the manual.

•Fasten the power cable properly.

•Install the power cable properly to prevent tripping over it.

•Install the power cable properly to prevent damage.

•Use one red (positive/+)and one black(negative/-) power cable to avoid confusion.

Battery

WARNING

•Improper connection of power cable wires (+,- polarity) causes the main fuse or safety fuse to disconnect in the microwave oven.

Be sure to connect +, - polarity in the proper way.

•Connect the power cable securely.

If not, the oven may not function correctly and could cause damage to the vehicle.

Be sure to connect the cable with proper torque (30~50kg.cm)

Connect the oven to the user’s battery (a secondary battery) if possible. Connecting to the starter battery may overload the appliance, which in turn may cause the engine to not turn over.

•Make sure there is sufficient Battery Capacity. The battery capacity should be at least 90Ah for 12V operating voltage.

Power Cable Size and Power Cable Length

For a 3m wire, the size should be a minimum

22mm2 (4AWG) for 12V of operating voltage.

For a power cable more than 3m in length, the size must be larger in order to reduce the voltage drop. If the voltage drop is too much, the oven may not operate properly.

•If you have used the microwave oven for longer than 10 minutes, keep your vehicle’s engine running for 2~3 minutes to avoid battery drain.

MICROWAVE OVEN INSTALLATION REQUIREMENTS 9

Page 46 Page 48
Image 47
Page 46 Page 48
Contents Mikrowellengerät Sicherheitshinweise Beim Umgang MIT MIKROW- Ellen Bitte BeachtenWichtige Sicherheitshinweise Fortsetzung SicherheitshinweiseWährend, aber immer nach dem Garen um Allgemeine SicherheitshinweiseSpezifikationen Installation des MikrowellengerätsElektrische Spezifikationen Installation des MikrowellengerätsInstallation Für die Installation erforderliches Zubehör und WerkzeugeVorderseite des Mikrowellenherds Installation FortsetzungAbb Das Stromkabel fängt eventuell Feuer. Ein Airbag platzt auf Sicherheitshinweise zum Installieren des MikrowellengerätsElektrische Anschlüsse StromkabelKabelstärke und -länge BatterieLeistungsaufnahme der Batterie bei nor- malem Gebrauch Stromkabel an das Mikrowellengerät anschließenMikrowellengerät vorbereiten Ihr MikrowellengerätBauteile prüfen Taste zum Öffnen der Garraumtür Tasten auf dem BedienfeldTaste zum Anhalten des Garvorgangs Taste zum Starten des GarvorgangsSpeisen automatisch aufwärmen GeräteverwendungGar- bzw. Aufwärmzeiten einstellen HinweisEmpfehlungen SymbolTabelle Auto Die Taste +30 s verwendenCode Fehler Ursache Behebung Die Löschtaste verwenden FehlercodesVorgehensweise Mikrowellengeeignetes Geschirr GaranleitungGartechniken Der Drehteller macht Geräusche oder steckt fest AnhangSpezifikationen Mikrovågsugn Spara Dessa Instruktioner Ex Barnmatsburkar Lufttät mat Viktiga säkerhetsinstruktioner, fortsättningFat och behållare kan bli heta. Var försiktig Säkerhetskrav Er nya mikrovågsugn Installationskrav för mikrovågsugnBaksida TillagningsinstruktionerLevererade artiklar Nödvändiga artiklar för installationenInstallation KravMikrovågsugnens framsida Installation fortsättningVisar hur ugnen ska se ut när den är fäst på ramen Anslut elkabeln säkert Säkerhetskrav för installationBatteri ElledningarBatteriförbrukning för korrekt drift Ansluta elströmkablarna till ugnenRulledarring Kontrollera delarTack för att ni har valt Samsung Placering av er mikrovågsugnTryckknapp KontrollpanelknapparTryck för att ställa in tillagningstiden Start +30 s knappViktig anmärkning Ställa in tillagningstiderAutomatisk uppvärmning AutomattabellAnvända återställnings knappen Felposter Kod FelsignalAnvända Start +30 s knappen FelkoderVaxpapper Används som skydd för att förhindra stänk KokkärlTesta redskap Allmänna tips TillagningsteknikerKontrollera om behållaren kan användas i mikrovågsugn FelsökningsguideSkötsel och rengöring Specifikationer Microwave Oven Exposure to Excessive Microwave Energy To reduce the risk of fire in the oven Important Safety InstructionsPrecaution! Safety Requirements Back Cover Microwave Oven InstallationCooking Instructions Your New Microwave OvenMicrowave Oven Supplied Items Items needed for InstallationRequirements Front of Microwave Oven Take the oven’s weight into accountIncluding a vehicle’s sudden stop or acci- dent Screws Tap Screws Power Cable Size and Power Cable Length Safety Requirements for InstallationElectrical Wiring Battery Power Consumption for proper operation Connecting the Power Cables to the OvenModel Number Serial Number Setting Up Your Microwave OvenChecking Parts Thank You for Choosing SamsungStart +30 s Button Display Auto Reheat Button Time setting ButtonsCancel Button Control Panel ButtonsImportant Remark Auto ChartReheating Automatically Open the door Oven light will turn onError Items Code Using the Start +30 s ButtonUsing the Cancel Button Error CodesThermometers Use only those labeled Testing UtensilsCooking Utensils General Tips Cooking TechniquesTurntable makes noises or sticks Troubleshooting GuideCare and Cleaning You see sparks or arcingSpecifications
Related manuals
Manual 18 pages 5.87 Kb

DE7711 specifications

The Samsung DE7711 and DE7711N are innovative digital signage displays designed to captivate audiences and enhance visual communication. Combining striking aesthetics with advanced technology, these models are particularly suited for retail environments, corporate settings, and public spaces, making them ideal for businesses looking to convey impactful messages.

One of the main features of the Samsung DE7711 is its stunning visual clarity. With a display resolution of 1920 x 1080 pixels, it delivers sharp images and vibrant colors, ensuring that content is presented in a visually appealing manner. The display utilizes advanced panel technology that enhances the brightness and contrast levels, allowing for excellent visibility even in well-lit environments. The DE7711N model further improves upon this by incorporating a higher brightness level, making it perfect for outdoor or high-ambient-light scenarios.

Durability is another key characteristic of the Samsung DE7711 series. These displays are built to withstand the rigors of constant operation, with a robust design that ensures reliability in various environmental conditions. They are equipped with anti-reflection glass that minimizes glare and enhances visibility, ensuring that presentations or advertisements are easily readable from various angles.

Connectivity is seamless with the Samsung DE7711 and DE7711N, featuring multiple input options, including HDMI, USB, and DisplayPort. This versatility allows for easy integration with a variety of media players and control systems, facilitating smooth content management. The built-in media player capabilities enable users to display multimedia content directly from USB storage, simplifying setup and operation.

Both models also support Samsung’s MagicINFO software, which allows users to create, manage, and schedule content with ease. This integrated content management system empowers businesses to engage with their audience effectively, optimizing the impact of their messaging.

Energy efficiency is a notable aspect of the DE7711 series, as these displays are designed to consume less power without compromising performance. This not only contributes to cost savings but also aligns with eco-friendly business practices.

Overall, the Samsung DE7711 and DE7711N are formidable solutions for any organization aiming to boost their visual presence. Their combination of high-performance display technology, robust design, and user-friendly features makes them a valuable addition to any digital signage strategy.
Top Page Image Contents