Sirius Satellite Radio PMA8000-SR Post Installation Checkout, Required Test Equipment

Page 21

PS Engineering

PMA8000-SR Series Audio Selector Panel and Intercom System

Installation and Operator’s Manual

2.9Post Installation Checkout

After wiring is complete, verify power is ONLY on pins 8 and 9 of the J2 and airframe ground on connec- tor pins 10 and 11. Failure to do so will cause serious internal damage and void PS Engineering's war- ranty.

2.9.1Required Test Equipment

In order to return an aircraft to service after installation of the PMA8000-SR, the installer must have access to a Marker Beacon signal generator:

a.IFR NAV401L, NAV402AP, IFR4000

b.TIC T-30D, T-36C

Equivalent test equipment is acceptable as long as the testing requirements can be met.

2.10Unit Installation

To install the PMA8000-SR, gently slide the unit into the mounting rack until the hold-down screw is en- gaged. While applying gentle pressure to the face of the unit, tighten the 3/32" hex-head in the center of the unit until it is secure. DO NOT OVER TIGHTEN.

Caution: Apply steady pressure to the bezel while screwing the unit into the tray to

ensure even seating of the unit and connectors.

Warning: Do not over-tighten the lock down screw while installing the unit in tray.

Internal damage will result.

2.10.1 Operational Checkout

NOTE: The IntelliVox® is designed for ambient noise levels of 80 dB or above. Therefore some clipping may occur in a quiet cabin, such as without the engine running, in a hangar. This is normal.

1.Apply power to the aircraft and avionics.

2.Plug headsets into the pilot, copilot, and occupied passenger positions.

3.Verify fail-safe operation by receiving and transmitting on com 1 from the pilot position, with the au- dio panel power off. The Com audio will be present in one ear cup only.

4.Switch on the unit by pressing the volume (VOL) knob.

5.Check intercom operation.

6.Push the Com 1 Xmt select button (lower row).

7.Verify that both of the Com 1 buttons light. Verify that transmit button LED (Light Emitting Diode) near the mic selector is not blinking. If the LED is blinking, stop testing and troubleshoot the micro- phone PTT installation.

8.Verify proper transmit and receive operation from the copilot position, noting that the copilot PTT switch allows proper transmission on the selected transceiver. Verify that the Com 1 Xmt button blinks when transmitting.

9.Verify that pushing the COM 2 button causes the button to illuminate, and the Com 2 receiver to be heard. Verify operation on Com 1 from the pilot position.

10.Repeat for Com 2

11.Press and hold the Com 1 Xmt button. While holding the Com 1 button, press the Com 2 Xmt button. This places the unit in “split Mode;” Verify that the pilot can transmit and receive on Com 1, while the copilot transmits and receives on Com 2.

12.Verify proper operation of all receiver sources by selecting them using the appropriate button. The button illuminates to show which source is in use.

200-880-0000

Page 2-13

Rev. 13, July 2006

Image 21
Contents PS Engineering, Inc PMA8000-SRMarker Beacon Installation Rev , July 12.2Introduction Section I General InformationTSO Approval. C50c, C35d Approval BasisDME, MKR, AUX Audio Selector SpecificationsRequired Test equipment to check installation PMA8000 Installation Kit Description Quantity Part NumberRecord your Radio ID here for future reference Section II Installation Equipment Installation ProceduresUnpacking and Preliminary Inspection Audio Panel Tray and Connector Assembly Audio Panel Mounting Rack InstallationConnector Pin crimping tools Cable Harness WiringPower Existing GMA340 InstallationCommunications Push-to-Talk Audio Panel interfaceTEL Duplex Function for Cell Phones Patented Swap ModeTransmit Interlock BacklightingPublic Address Mode Unswitched inputsIntercom wiring PA Mute J2, PinSirius Satellite Radio Functions Sirius Satellite Radio InstallationEntertainment distribution Sirius Radio Output JumpersPMA8000-SR using PXE7300 as control Entertainment muting PMA8000-SR using PAV80 as controlAdjustments Marker Beacon InstallationAudio Active Output Communications Antenna Installation NotesFunction PMA8000-SR Pin assignmentsSAT Radio output Lt Com 2 Mic KeyUnit Installation Post Installation CheckoutRequired Test Equipment Internal damage will resultMarker Beacon Checkout Sirius Signal DropoutTEL Checkout Sirius Satellite Radio checkoutSirius Satellite Radio ID number Internal Recorder Checkout OptionalFinal Inspection Power Switch 1 EMG-Fail Safe Operation Section III OperationMicrophone 2 XMT Selection All models Audio Selector Swap Mode Switch from Com 1 to Com 2 remotelySpeaker Amplifier Public Address InitializationMute Button, Split Mode ICS Split ModePublic Address Function Intercom OperationMono headsets in Stereo Installation Intercom Volume ControlMic Muff Part Numbers Intercom ModesSoft Mute and Soft Mute inhibit for Karaoke Mode Entertainment InputIntercom Modes Telephone Mode Capability when the cellphone is in useSirius Satellite Radio Operation Sirius Radio Front Panel Controls Front panel control of Sirius RadioMarker Beacon Operation Internal Recorder System OptionOperation Section IV- Warranty and Service WarrantyFactory Service Appendix a Rev , July Appendix a External PTT Hook UpAppendix B Rev , July Appendix B PMA 8000 Installation DrawingsAntenna Coax Supplied Appendix C Rev , July Appendix C, J1 InterconnectAppendix D Rev , July Appendix D, J2 Connector InterconnectInstructions for FAA Form 337, Audio Panels Instructions for Continuing Airworthiness, Audio SystemAppendix E Rev , July Appendix F Rtca DO160D Environmental Qualification Form Conditions Section Conducted TestsAppendix G Rev , July

PMA8000-SR specifications

The Sirius Satellite Radio PMA8000-SR is a renowned device that integrates advanced technology with user-friendly features, making it a staple for audio enthusiasts seeking a comprehensive satellite radio experience. As part of Sirius’ expanded offerings, the PMA8000-SR provides listeners with a robust selection of channels, ensuring there's something for everyone, from music and news to sports and entertainment.

One of the standout features of the PMA8000-SR is its ability to receive a vast array of satellite radio channels, offering over 150 options that cover a range of genres. This includes commercial-free music, exclusive talk shows, sports coverage, and even comedy channels. The device is designed to deliver high-quality audio, ensuring that listeners enjoy crystal-clear sound, free from the distortions often associated with traditional radio.

The PMA8000-SR incorporates digital signal processing technology which enhances audio clarity and ensures stable reception. With a user-friendly interface, the device allows users to easily navigate between channels and access key functions with minimal effort. The large display screen provides essential information at a glance, including channel names, song titles, and artists.

For in-car use, the PMA8000-SR features seamless integration with vehicles equipped for satellite radio, allowing for an uncomplicated installation process. The device supports multiple installation options, catering to various audio systems with both wired and wireless capabilities. The versatility of the PMA8000-SR ensures that it can be utilized in different environments, whether you're on a long road trip or relaxing at home.

Another notable characteristic is the built-in recording feature, allowing users to capture their favorite shows and music for later enjoyment. The device also includes pause and rewind functionalities, enabling listeners to take control of their audio experience without missing a beat. Additionally, with the compatibility for advanced features such as traffic and weather information, the PMA8000-SR goes beyond traditional radio limitations, providing real-time updates that help enhance driving convenience.

Overall, the Sirius Satellite Radio PMA8000-SR stands out due to its rich feature set, enhanced audio technologies, and exceptional versatility. It’s an ideal choice for those who crave a diverse audio experience with cutting-edge functionality, ensuring that listeners remain entertained wherever they go.