Sharp R-930CS, R-930AK Installation Instructions, Applicable Applicable G.E, Built-in kits

INSTALLATION INSTRUCTIONS

Unpacking and Examining Your Oven

Remove:

1.all packing materials from inside the oven cavity. Read enclosures and SAVE the Operation Manual. DO NOT REMOVE AND THROW OUT THE WAVE GUIDE COVER.

2.the feature sticker from the outside of the door, if there is one.

Check the oven for any damage, such as misaligned or bent door, damaged door seals and sealing surfaces, broken or loose door hinges and latches and dents inside the cavity or on the door. If there is

Hinges

Oven Cavity

Door Seals and

any damage, do not operate the oven and contact your dealer or SHARP AUTHORIZED SERVICER.

Latches

Sealing Surfaces

Choosing a Location for Your Oven

You will use your oven frequently so plan its location for ease of use. The oven must be placed on a countertop which is a minimum of 36 inches from the floor. Allow at least 2 inches on the sides, top and at the rear of the oven for air circulation. Be sure to position oven so that the rear cannot be touched

inadvertently.MIN. 11/2"

Your oven can be built into a cabinet or wall by itself
or above any General Electric wall oven using Sharp’s
Built-in Kit listed below. It cannot be built in above
conventional gas or electric ranges or any other wall	MIN.
ovens.	36"

Sharp Microwave	Applicable	Applicable G.E.
Oven Model	Built-in kits	Wall Ovens
R-930AK	RK-66A	JKP18BW
		JKP18WW
R-930AW	RK-66WB
		JKP18AW
R-930CS	RK-93S27
	RK-93S30
		ZET-837SYSS

GE Electric Wall oven.

Sketch-1

Note for R-930CS:

Select the Built-in kit RK-93S27 or RK-93S30 depending on the desired finished width. The RK-93S27 is for a 27 inch and the RK-93S30 is for a 30 inch finished width. The RK-93S27 cannot be used with any of the G.E. wall ovens.

See Sketch 1 for proper location when building in above the specified G.E. wall ovens. Carefully follow both the G.E. wall oven installation instructions and Sharp’s Built-in Kit instructions. Be sure that the clearance of the floor between the wall oven and the microwave oven is minimum of 11/2 inches.

Ordering the Built-in Kits.

If your dealer does not stock the kit, it can be ordered directly from the Sharp Accessories and Supplies Center. Have your credit card number available and call toll-free: 1-800-642-2122 for ordering the kit to be sent to your address.

The kit includes ducts and finish trim strips and easy-to-follow instructions for installation as well as the location of the power supply.

3