Fisher & Paykel CG733 installation instructions Connecting the appliance to Natural or Town GAS

Page 15

Installation instructions 13

Connecting the appliance to NATURAL or TOWN GAS

1If not already fitted, fit the NATURAL/TOWN GAS hose holder on the inlet pipe, making sure that you place the sealing washer between them (as shown in Fig. 5a).

2Connect the appliance to the gas supply using a suitable rubber hose (internal diameter 13 mm). The hose must comply with the applicable local regulations and be of the correct construction for the type of gas being used.

3Make sure that the hose is tightly and securely fitted at both ends.

4 Use a standard hose clamp (not supplied) to fasten the hose.

Connecting the appliance to LPG

1If not already fitted, fit the LPG adaptor on the inlet pipe, making sure that you place the sealing washer between them (as shown in Fig. 5a).

EN

Important!

The LPG hose holder is formed by screwing the LPG hose adaptor into the bottom end of the NATURAL/ TOWN GAS hose holder, (with the sealing washer placed in between them).

2Connect the cooktop to the gas supply using a suitable rubber hose (internal diameter 8 mm). The hose must comply with the applicable local regulations and be of the correct construction for the type of gas being used.

3Make sure that the hose is tightly and securely fitted at both ends.

4Use a standard hose clamp (not supplied) to fasten the hose.

5Install a gas pressure regulator.

Important!

To comply with applicable local regulations, a gas pressure regulator (conforming to the current local regulations) must be installed when connecting the appliance to an LPG cylinder.

When connecting the appliance to the gas supply with a rubber hose, make sure that

the hose is as short as possible, without twists or kinks.

the hose is not longer than 750 mm (or refer to applicable local regulations) and does not come into contact with sharp edges, corners or moving parts. Use a single rubber hose only; never connect the appliance with more than one rubber hose.

the hose is not under tension, twisted, kinked, or too tightly bent, neither while the appliance is in use nor while it is being connected or disconnected.

the hose does not come into contact with any part of the appliance with a surface temperature of 70°C or above (or refer to applicable local regulations).

the hose is not subject to excessive heat by direct exposure to flue products or by contact with hot surfaces.

the hose can easily be inspected along its entire length to check its condition.

the hose is replaced at the printed due date or if it shows signs of wear or damage, and replaced regardless of its condition after a maximum of three years.

you inform the customer that the gas cylinder valve or the gas supply valve immediately by the appliance should be closed when the appliance is not in use.

you inform the customer that the hose should not be subjected to corrosion by acidic cleaning agents.

Image 15
Contents 安装说明 Page Contents Installation Safety and warningsSafety and warnings Safety and warnings Operation Cooktop and cutout dimensions EN 6 Installation instructionsClearances Installation instructionsThermal protection barrier must be EN 8 Installation instructionsProviding adequate ventilation Ventilation requirementsFastening the cooktop to the bench EN 10 Installation instructionsGas installation requirements Gas connection with rubber hose holder Gas Connection Gas connection with a rubber hoseConnecting the appliance to Natural or Town GAS Do not use any naked flame to check for leaks Gas connection with rigid pipes or a flexible hoseTesting operation Converting the cooktop to a different gas type EN 16 Installation instructionsTable for the choice of injectors Reduced Power WElectrical connection Colour of power supply cable wireTo be Completed by the Installer Final checklistBefore using your new cooktop IntroductionAbout your new cooktop Gas burners Using your cooktop 21 ENUsing the burners Flame failure safety featureUsing your cooktop If a burner does not lightIf the flame is irregular Using your cooktop 23 EN Symbols on the glass Before any cleaning or maintenance, make sure that General adviceCleaning chart Care and cleaningEnsure the burner and pan support are replaced correctly Replacing the semi-rapid burner and pan supportReplacing the triple-ring wok burners and pan supports Pay special attention to the triple-ring wok burners Cleaning the triple-ring wok burners cupProblem Possible solutions TroubleshootingWarranty and service Before you call for service or assistanceProduct details Page Page Page 重要! 燃气灶只能由授权人士进行维修。 在进行任何维护或修理之前,始终要断开燃气灶供电电源。 割伤危险 小心 面板边沿很锋利。 如不小心,可能会造成人身伤害或割伤。触电危险 在处理燃气灶的电气部分之前,必须断开供电电源。 必须连接良好接地线。 否则,可能会造成死亡或触电。 在安装或使用燃气灶之前仔细阅读说明书。 请让燃气灶安装人员阅读此信息,因为这可以降低安装成本。安全警告 CN 38 安全警告 燃气灶尺寸和开口尺寸 安装说明 39 CNCN 40 安装说明 必须在燃气灶底面与嵌入式设备或烤箱之间安装绝热层。参看下面的图1。 安装说明 41 CN绝热层必须: 必须根据适用法律把燃气灶安装在合适的厨房里。 燃气灶仅供家庭使用,切勿安装在商业、半商业或公共环境下使用。排出油烟和燃烧产生的废气 CN 42 安装说明通风要求 实现良好通风 安装人员必须遵守当地的适用法规。 安装燃气灶的厨房必须有良好的自然通风,以利于燃气 充分燃烧。把燃气灶固定在灶台上 安装说明 43 CN如果安装错误,可能会造成保修失效。 燃气灶只能使用天然气、液化石油气或民用煤气(参看燃气灶的燃气调节标签)。 安装说明燃气连接 用橡胶软管连接燃气接头注意:可以在允许的情况下用橡胶软管连接燃气,也可以用软钢管或硬钢管连接燃气。 在用橡胶软管把燃气灶连接到燃气接头时,确保: 软管要尽可能短,不得缠绕或打结。 把燃气灶连接到天然气或民用煤气接头上确保把软管的两端拧紧。 使用标准软管夹(不随机提供)固定软管。 把燃气灶连接到液化石油气接头上 确保把软管的两端拧紧。 使用标准软管夹(不随机提供)固定软管。 安装气压调节阀。注意:如果进气管安装了橡胶软管接头,把它从进气管接头上卸下来 用硬钢管或软钢管连接燃气接头在把燃气灶连接到燃气接头上之后,确保 燃气接头(图5b)包括: 燃气灶进气管 浮动螺母 黄铜弯头更换有损坏迹象的硬钢管或软钢管。 软钢管不受烟道直接加热,不接触热表面。 测试工作不喷火焰,增大最小气速设置。 安装说明 49 CN把燃气灶连接到不同的煤气接头上 调节灶头最小气速设置降低功率W 喷嘴选择表电气连接 下列检查应该由安装人员进行 最后检查如要了解详情,请访问封地列出的地区网站。 请你在使用新燃气灶之前: 阅读本用户指南,要特别留意安全警告一节。 确保接通燃气灶电源。中火灶头 左三环铁锅灶头旋钮 中火灶头旋钮 右三环铁锅灶头旋钮 旋钮(图11)控制流过安全阀的气流。 切勿把旋钮打到最大位 燃气灶头使用灶头 熄火安全装置在保养和清洁一节所示的位置 同时参看故障排除一节。 如果灶头不点火如果火焰异常 检查:CN 56 使用燃气灶 把平底锅放在灶头中央使其保持稳定,不悬在燃气灶外面。 只使用随机提供的铁锅锅圈或燃气灶制造商建议的铁锅锅圈。 玻璃上的符号含义切勿用蒸汽清洁器清洁燃气灶的任何零部件。 一般性建议在清洁或维护之前确保: 关闭所有灶头 燃气灶断开了电源 燃气灶的所有零部件冷却到可以安全触摸的程度 切勿让酸性物质(柠檬汁、醋等)遗留在灶面上。分火盘1 用硬尼龙刷或拉直的回形针 清洁孔和凹槽。 用温热肥皂水清洗。 冲洗干净,然后擦干。 保养和清洁清洁流程图 在清洁热表面时要非常 小心!水平稳定 正确对准 放回中火灶头和平底锅锅圈放回三环铁锅灶头和平底锅锅圈 清洁三环铁锅灶头喷嘴 点火器可能脏了。用牙刷蘸甲基化酒精清洁点火器。 灶头不点火 检查是否插好燃气灶电源插头,是否接通电源。听到燃气发出的嘶嘶声。 如果使用罐装燃气,检查液化气罐是否空了。保修和服务 在致电寻求服务或协助之前⋯⋯产品资料 Page SG HK

CG733 specifications

Fisher & Paykel CG733 is a distinguished gas cooktop designed to elevate your culinary experience. This model combines sophisticated design with advanced technology, catering to both professional chefs and home cooking enthusiasts.

One of the standout features of the CG733 is its powerful burners. It comes with a total of five gas burners, including a dual-flame burner that offers exceptional versatility. This dual-flame technology allows users to switch between high and low heat settings effortlessly, making it ideal for everything from rapid boiling to gentle simmering. Each burner has a robust BTU output, providing the necessary power for demanding cooking tasks.

The cooktop is equipped with a cutting-edge ignition system known as Pilotless Ignition. This feature enhances safety by eliminating the need for a standing pilot light, while ensuring that igniting the burners is as simple as turning the knob. Moreover, the CG733 incorporates a flame failure device that automatically shuts off the gas supply if the flame is accidentally extinguished, offering peace of mind in the kitchen.

Another important characteristic of the CG733 is its sleek and modern design. The cooktop features a minimalist look with stainless steel construction, providing durability while easily blending with various kitchen styles. The high-grade finish is not only aesthetically pleasing but also easy to clean, making maintenance straightforward.

Fisher & Paykel has also prioritized user comfort with the CG733 by incorporating ergonomic control knobs. These knobs are positioned for easy access and intuitive use, allowing for precise flame adjustment. Furthermore, the cooktop includes continuous grates made from cast iron, providing a stable cooking surface for pots and pans of all sizes. This design ensures smooth movement of cookware across the surface, reducing spills and enhancing convenience during meal preparation.

In terms of installation, the CG733 is designed for built-in configurations, allowing for seamless integration into your kitchen layout. With its combination of powerful performance, modern safety features, and elegant design, the Fisher & Paykel CG733 gas cooktop is an excellent choice for anyone looking to enhance their cooking capabilities while adding a touch of style to their kitchen space. Whether you're sautéing vegetables, searing meats, or simmering sauces, this cooktop is designed to meet all your cooking needs with precision and ease.