LCD Norm | Fast | Deli | Rinse | Hardware Output | |
bL | Off | Off | Off | On | Backlight |
Er | Off | Off | On | Off | Element Relay (turns off after 5 seconds) |
Ld | Off | Off | On | On | Lid Motors (will run for 10 seconds) |
dd | Off | On | Off | Off | Detergent Diverter Valve |
FU | Off | On | Off | On | Fill Water Valve |
P1 | Off | On | On | Off | Motor Wash direction |
P2 | Off | On | On | On | Motor Drain direction 4200 rpm (times out after 255 seconds.) |
rd | On | Off | Off | Off | Rinse Aid Dispenser (dispenses according to current user setting) |
dF | On | Off | Off | On | Drying fan |
LE | On | Off | On | Off | Rinse Aid and Salt Tank LEDs |
C1 | On | Off | On | On | Water Softener Diverter Valve |
C2 | On | On | Off | Off | Water Softener Brine Pump |
C3 | On | On | Off | On | Water Softener Brine Valve |
°C | On | On | On | Off | Displays current water temperature. |
°E | On | On | On | On | Displays controller rail voltage |
(C3 is used in the factory to empty the water softener before the product is packed.)
Tub Home Sensor Test: At any time during HO test mode the Keylock symbol on the LCD display (Keylock LED on integrated badge) indicates the tub position. On = closed, off = open.
Press POWER to skip hardware diagnostics and exit mode.
5.1.3Fast Test Cycle – Level Three
WARNING : Only run this cycle if connected to the water supply.
This level runs an
Flat door and Integrated will show the following LED’s on secondary display panel.
Pre Finished
Integrated and Flat Door Models
Will show the following LED’s on secondary
display panel
Press POWER to skip Fast Test Cycle and advance to the next level. Press START/PAUSE to enter Fast Test cycle.
18