COMMERCIAL RECEIVER &
TRANSMITTER CODING INSTRUCTIONS
The information below indicates how to set the coding switches in the various transmitters and receivers.
IF YOU ARE USING A 8833
Exactly match all 8 code switches in the transmitter and receiver. The code switches may be set in any random pattern of +, - and 0.
IF YOU ARE USING A 8833C
This transmitter is used to control up to 3 different doors. This is accomplished by setting the selector switch on the transmitter to either A, B & C and setting the #6 coding switch in the 831 receiver .
TRANSMITTER | RECEIVER |
| Coding Switch |
Switch Position | #6 |
A | + |
|
|
B | 0 |
|
|
C | - |
|
|
Start coding by exactly matching all 8 code switches in the transmitter and the receivers. The code switches may be set in any random pattern of +, 0 and - positions. Next, in receiver A, set code switch #6 to the + position; In receiver B set code switch # 6 to the 0 position; In receiver C set code switch # 6 to the - position. The table to the right shows the switch positions.
IF YOU ARE USING A 639 STANDARD TRANSMITTER:
This transmitter is used to control up to 9 different doors. This is accomplished by setting the selector switch on the transmitter to either 1, 2, 3, 4, 5, 6, 7, 8 or 9 and setting the #7 and #8 coding switches in the 831 receiver.
Start coding by exactly matching all 8 code switches in the transmitter and receivers. The code switches may be set in any random pattern of +, 0 and - positions. Next, in receiver 1, set code switch #7 to + and code switch #8 +; In receiver 2, set code switch #7 to + and code switch #8 to 0. Continue setting the codes in the 831E receivers as shown in the table.
IF YOU ARE USING A 535 STANDARD TRANSMITTER:
This transmitter is used to control up to 27 different doors. This is accomplished by setting the selector switches to either A, B or C and either 1, 2, 3, 4, 5, 6, 7, 8 or 9 and setting the #6, #7 and #8 coding switches in the 831 receiver.
TRANSMITTER |
|
|
1 - 9 Selector | 831 RECEIVER | 831 RECEIVER |
Switch Position | Code Switch #7 | Code Switch #8 |
1 | + | + |
|
|
|
2 | + | 0 |
|
|
|
3 | + | - |
|
|
|
4 | 0 | + |
|
|
|
5 | 0 | 0 |
|
|
|
6 | 0 | - |
|
|
|
7 | - | + |
|
|
|
8 | - | 0 |
|
|
|
9 | - | - |
|
|
|
Start coding by exactly matching all 8 code switches in the transmitter and receiver. Next, in receiver A1, set code switch #6 to +, set code switch #7 to + and code switch #8 to +; In receiver A2, set code switch #6 to +, set code switch #7 to + and code switch #8 to 0. Continue setting the codes in the 831 receivers, using both tables shown above.
WARNING
DISCONNECT POWER AT FUSE BOX AND DOOR OPENER BEFORE WIRING
PERMANENTLY TO PREVENT ELECTROCUTION.
Page 3 of 4 | P/N 107343 Rev D |