Dimensions and Specifications in inches | GE ZIFI240PLII specification

ZIFI240PII – GE Monogram Fresh-Food Refrigerator Module

(Custom panel required) )

ZIFS240PSS – GE Monogram Fresh-Food Refrigerator Module

(Stainless steel)

Dimensions and Specifications (in inches)

For a complete food storage center, install two Monogram refrigeration modules side-by-side.

Note: Reversible door swing on wine chillers/reserves and beverage centers only. See below for combination cutout dimensions.

Important Note: Products must operate from separate, properly grounded receptacles.

Locate Outlets 24"

3/4” Overlay Panel Dimensions

Model ZIFI240PII requires customer-provided overlay door panel.

•The overlay panel must be secured to a 1/4" thick backer panel which slides into the trim. A .10" thick spacer panel must be placed between the custom and backer panel.

•A custom handle of your choice, supplied by your cabinet maker, must be installed on the overlay panel.

Overlay

Panel

Door

1/4"

Backer .10 Inch

Panel Spacer

10-1/2"10-1/2"

24" Min.

9"9"

34-1/2" - 35"Max.Max.

1-1/2"1-1/2"

47-1/2" Min.

Note: Additional cutout width may be required for models with custom panels.

Grounding the Fresh-Food Refrigerator

IMPORTANT – (Please read carefully)

Use a 3/4" router bit to cut a notch into the back side of the assembled panel to allow for hinge clearance.

		3/4" Overlay Panel Dimensions (in inches)
			A (Width)	B (Height)
			A (Width)	B (Height)
		1/4" Backer	23-3/16"	29-9/16"
3/4" Deep		0.10" Spacer	22-1/2"	29-1/16"
7/8" Wide		3/4" Overlay	23-5/8"	30"
3/8" toward
3/8" toward	B	NOTE: Max. assembled drawer panel weight
the front side		NOTE: Max. assembled drawer panel weight
the front side		is 25 lbs.
Back Side		is 25 lbs.
Back Side
of Panel

FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.

The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance.

Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.

When a standard 2-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall out.

Assemble overlay panels with glue and screws.

•Center spacer panel on the backer panel, left to right and top to bottom. Secure the panels with glue.

•Center the spacer/backer panel on the overlay panel. Secure with glue and screws. Countersink screws into the backer panel.

Overlay Panel

Spacer Panel

Backer Panel

DO NOT, UNDER ANY CIRCUMSTANCES,

CUT OR REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD.

DO NOT USE AN ADAPTER PLUG TO CONNECT THE REFRIGERATOR TO A 2-PRONG OUTLET.

DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE.

Specification Revised 7/05

Listed by

Underwriters

RLaboratories

For answers to your Monogram,® GE Proﬁle™ or GE® appliance questions, visit our website at GEAppliances.com or call GE Answer Center® service, 800.626.2000.

120032