GE ZIFS240PLSS dimensions Models with a Custom Door Panel, Stainless Steel, Cutout depth must be

ZIFI240PII – GE Monogram Fresh-Food Refrigerator Module

(Custom panel required)

ZIFS240PSS – GE Monogram Fresh-Food Refrigerator Module

(Stainless steel)

Dimensions and Specifications (in inches)

Product Clearances

Installation Space

	Locate Outlet
	10-1/2"
	9"	24" Min.
34-1/2"-35"	Max.	23-3/4" Stainless Steel
	1-1/2"	Models
		24-7/8" Framed Models
	23-3/4" Min.
	Depth Including
	Handle:

Models with a Custom Door Panel

24"

Cabinet

Wall

110˚

16" Minimum

Stainless Steel

Models

24"

Cabinet

Wall

110˚

14" Minimum

26" Stainless Steel	34-1/2"
Models Only
Note: If installing between frameless
cabinets, a 1/2" wide filler strip or side panel
may be required. The filler strip will act as a	23-3/4"
spacer between the door case and adjacent cabinet
and will prevent interference with cabinet door swing.
The width of the opening must include filler panels.

The cutout depth must be 24"

The cutout dimensions shown allow for a full door swing and access to the pull-out racks when installed as a built-in.

•The Fresh-Food Refrigerator can be free-standing.

•The stainless steel model ZIFS240PSS can be installed flush with standard cabinetry. ZIFI240PII with custom panel will project forward 1-3/4" of adjacent 24" deep base cabinets.

•Note: Door swing is not reversible.

Additional Specifications:

•A 120 volt 60Hz., 15 or 20 amp power supply is required. An individual property grounded branch circuit or circuit breaker is recommended. Install a properly grounded 3-prong electrical receptacle recessed into the back wall as shown. Electrical must be located on rear wall as shown. Note: GFI (ground fault interrupter) is not recommended.

All models are factory set for a 110° door swing.

For a minimum 90° door swing:

•Allow 4" min. clearance to wall on the hinge side for Stainless Steel models.

•Allow 4-1/2" min. clearance to wall on the hinge side for models with a custom panel and custom handle.

For a full 110° door swing:

•Allow 14" min. clearance to wall on the hinge side for Stainless Steel models.

•Allow 16" min. clearance to wall on the hinge side for models with a custom panel and custom handle.

Listed by

Underwriters

RLaboratories

	For answers to your Monogram,® GE Profile™ or
	GE® appliance questions, visit our website at
Specification Revised 7/05	GEAppliances.com or call GE Answer Center®
	service, 800.626.2000.

120032