Questions? Use this problem solver!
|
| The Problem Solver |
| |
|
|
|
|
|
|
|
|
| |
|
|
|
| |
| PROBLEM | POSSIBLE CAUSE |
| |
|
|
|
| |
| APPLIANCE | • Interior needs cleaning. See Care and Cleaning. |
| |
| HAS ODOR | • Keep open box of baking soda in appliance; replace every 3 months. |
| |
|
|
| ||
|
|
|
| |
| DOOR NOT CLOSING | • Door gasket is sticking or folding over. Apply petroleum jelly or |
| |
| PROPERLY | paraffin wax to the face of the gasket. |
| |
|
| • The door is hitting an internal component inside the |
| |
|
| appliance. Adjust interior components to prevent interference. |
| |
|
|
|
| |
| MOISTURE FORMS | • Not unusual during periods of high humidity. Wipe surface dry. |
| |
| ON OUTSIDE OF | • Door left open or package holding door open. |
| |
| APPLIANCE |
| ||
|
|
|
| |
|
|
|
| |
| MOISTURE | • Too frequent or too long door openings. |
| |
| COLLECTS INSIDE | • In humid weather, air carries moisture into appliance when doors |
| |
|
|
| ||
|
| are opened. |
| |
|
|
|
| |
| INTERIOR LIGHT | • No power at outlet. |
| |
| DOES NOT WORK | • Light bulb needs replacing. See Care and Cleaning. |
| |
|
|
| ||
|
|
|
| |
| HOT AIR FROM | • Normal air flow cooling motor. In the refrigeration process, it is |
| |
| BOTTOM OF | normal that heat be expelled in the area under the appliance. |
| |
| APPLIANCE | Some floor coverings are sensitive and will discolor at these safe |
| |
|
| and normal temperatures. |
| |
|
|
|
| |
| APPLIANCE | • Adaptive defrost keeps compressor running during door openings. |
| |
| NEVER SHUTS OFF | This is normal. The appliance will cycle off after the door remains |
| |
| BUT TEMPERATURES | closed for two hours. |
| |
| ARE OK | • Normal operation in extreme temperatures. |
| |
|
|
| ||
|
|
|
| |
| ACTUAL | • Unit just plugged in. Allow 24 hours for the system to stabilize. |
| |
| TEMPERATURE | • Door open for too long. Allow 24 hours for the system to stabilize. |
| |
| NOT EQUAL TO |
| ||
| • Warm contents added to appliance. Allow 24 hours for the system |
| ||
| SET TEMPERATURE |
| ||
| to stabilize. |
| ||
|
|
| ||
|
| • Defrost cycle is in process. Allow 24 hours for the system to stabilize. |
| |
|
| • Thermistor may be blocked, which can affect the overall temperature. |
| |
|
| The thermistor is located on the right hand side just above the |
| |
|
| third shelf. |
| |
|
|
|
| |
| TEMPERATURE | • Temperature may be in lockout mode. Press both + and – pads for |
| |
| WILL NOT ADJUST | 5 seconds to unlock the temperature. |
| |
|
| • Thermistor may be blocked, which can affect the overall temperature. |
| |
|
| The thermistor is located on the right hand side just above the |
| |
|
| third shelf. |
| |
|
|
|
|
|
18