Controls and Features
Glass shelves
Tempered glass shelves in the
To remove a shelf, open the door completely to avoid potential damage to the gasket. Lift up on the back of the shelf slightly. Tilt the shelf to one side at an angle while pulling forward.
Appearance may vary
To replace a shelf, open the door completely to avoid potential damage to the gasket. Tilt the shelf to one side
at an angle and slide toward the back wall, placing one side onto the shelf support. Place the other side onto the opposite shelf support. Ensure rear locking tabs are engaged. When installed properly, the shelf will not slide forward when gently pulled.
QuickSpace ™ Shelf
Loading tips and suggestions
To remove, lift up on the back of the shelf | Tilt the shelf at an angle while removing | Place in slots when replacing the shelf |
| or replacing |
|
This shelf splits in half and slides under | Step 1 |
itself for storage of tall items on the shelf |
|
below. |
|
Step 1: Lift the back edge of the front half |
|
of the shelf. | Step 2 |
|
Step 2: Pull slightly forward.
Step 3: Lower the back edge of the front half of the shelf while sliding it underneath the back half.
The entire Quick Space shelf can be removed and replaced (see Glass Shelves section).
Step 3
•Do not block the thermistor, located on the right hand side, just above the third shelf of the
9