Xerox 4500 PS TR instruction manual Installing upgrade modules, When IP address has been defined

Installation

Xerox 4500 PS TR

When IP address has been defined:

If the TCP/IP is enabled, the LAN LED will - if BOOTP parameter set to YES - start to flash as the Xerox 4500 PS TR tries to contact a BOOTP server. If no BOOTP server is availab le, the Xerox 4500 PS TR will use defaults. If valid default values are found , the LAN LED will remain lit.

The printer and network installation is now complete. For advanced configuration, see the chapter “Configuration of Xerox 4500 PS TR”.

2.6 Installing upgrade modules

This section provides installation guidelines for IPDS or FSL upgrade modules.

1.Disconnect all cables to the Xerox 4500 PS TR.

2.Loosen the thumbscrews and pull out the interface

3.Place the Xerox PS upgrade module (be it IPDS or FSL) on the 4 plastic spacers on the base module. Make sure that the pins on the connector J(x) fits correctly.

4.Remount the interface into the printer and fasten the 2 thumbscrews loosened in step 2.

5.Generate a settings printout to verify the installation of the upgrade module.

The printer and network installation is now complete. For advanced configuration, see the chapter “Configuration”.

FIRMWARE DOWNLOAD

Firmware download when the PrintServer is equipped with a top module can be done easily via Psinst32. See this section for details.

25