Xerox 4500 PS TR instruction manual Testing PrintServer

Configuration

Xerox 4500 PS TR

3.8Testing PrintServer

1.Perform a test printout by pressing the TEST key on the rear panel.

2.Verify that the settings match the definitions in the BOOTPTAB file and the bootfile. Appendix F contains settings printout.

3.‘’PING’’ the unit from the workstation to verify physical LAN and IP network connectivity.

a.Invoke the PING command and the IP address or host name of the unit. For example:

PING 192.0.110.1

b.If the PING is OK, you receive a system response like this:

PING 192.0.110.1: 56 data bytes

64 bytes from 192.0.110.1: icmp_seq=0. time=0. ms

64 bytes from 192.0.110.1: icmp_seq=1. time=0. ms

64 bytes from 192.0.110.1: icmp_seq=2. time=0. ms

64 bytes from 192.0.110.1: icmp_seq=3. time=0. ms

64 bytes from 192.0.110.1: icmp_seq=4. time=0. ms

....

....

3.Press CTRL-BREAK to end the PING process. You will then get the following output statistics:

----192.0.110.1 PING Statistics ----

5 packets transmitted, 5 packets received, 0% packet loss round-trip (ms) min/avg/max 0/0/0

NOTE:

If the PING does not reoccur, only reoccurs once, or if problems arise with another LAN device, please check the chapter on “Problem Determination”

85