Xerox 4500 PS TR instruction manual Appendix a Configuration Using Setup File

Appendix Section

Xerox 4500 PS TR

Appendix A: Configuration Using Setup File

You should only modify or change the settings via the bootfile for strictly necessary purposes.

Otherwise, you are recommended to use e.g.Telnet. (see the chapter on Configuration)

Appendix A 1: Configuring via parallel port

The default LAN and TCP/IP parameters may be set up via the parallel port.

If this method is used instead of using the configuration file, then the IP default (IP address gateway and subnet mask) must be specified in the configuration file when the Xerox 4500 PS TR is set up for the first time.

The configuration file must be sent via the centronics port.

NOTE:

On OS/2 workstations use IBMNULLas printer driver

On DOS or Windows use a Generic /Textprinter driver only.

1.Select the file you wish to send to the parallel port.

2.In this file you write the following command sequence at the top of the file: &&??##N1,0#<CR>

3.Type: END

4.To send the file, you write the following at the command prompt.

copy <filename> <lpt1>

where lpt1 is the PC’s centronics port.

5.For the settings to become effective you must either:

-turn the Xerox 4500 PS TR off and on or

-define the Xerox 4500 PS TR to boot from the configuration file

Type:

BEGIN_CONFIGURATION IDAPS

BOOT

END

6. Make a settings printout to verify the new settings.

158