Xerox 4500 PS TR instruction manual NetWare setup Bindery mode

Novell Setup for IPX/SPX

Xerox 4500 PS TR

4.4 NetWare setup - Bindery mode

This section describes the setting up of the NetWare version 3.1x or later for IPX/SPX printing using Bindery mode. If you use NetWare version 4.xx you should consider using DS mode as described in the next section.

NOTE:

You must either load the PSERVER.NLM on the server or define the embedded PRINTSERVER in the Xerox 4500 PS TR before connecting the NPRINTER.

1.Type “PCONSOLE” to start the PCONSOLE program

2.Make sure that you have selected the correct file server. If not, select the correct by selecting the menu " Change current file server".

3.Select “Print Queue Information” from the main menu to set up a queue to service the PrintServer.

4.Press INS to create a new queue and type a name for this new queue. The queue name is user-defined and used for printing and monitoring.

5.Select the new queue and press ENTER.

6.From the menu “Print Queue Information” select “Queue Server” and press ENTER.

7.Press INS for a list of Print Servers.

The list will show both non-embedded Print Servers and embedded Print Servers.

8.Select the appropriate Print Server from the list “Queue Servers Candidates” and press ENTER.

If defined on the system, one of the candidates is the embedded Print Server.

9.Press ESC three times to go to the main menu “ Available Options” and select “Print Server Information”.

10.Select the appropriate Print Server and press ENTER

11.From the “Print Server Information” menu select “Print Server Configuration”.

91