Pride Mobility Jazzy 600 XL owner manual Seat Installation, To install the seat

I V . A S S E M B L Y

SEAT INSTALLATION

It may be necessary to install the seat either prior to initial operation or after transporting your power chair. Most seats are attached to the power base with the Universal Mount- ing System (UMS). The UMS consists of universal parts that may be attached to any medium-back or high-back seat, regardless of seat width or seat depth. The two main components are aluminum extrusions mounted to the seat base. These extrusions attach to a pair of trapeze bars that are mounted to the power base. See figure 11.

WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so, resulting in personal injury or damage to the chair.

To install the seat:

1.Tilt the seat back and slide the rear extrusion onto the rear trapeze bar. See figure 11.

2.Lower the front extrusion onto the power seat base or front trapeze bar until the seat locks into place.

3.Flip the seat latch safety down. See figure 11.

WARNING! Make sure the seat latch safety is flipped down before using your power chair.

4.Install the controller into an armrest and route the cable to the back of the power base. See figure 12.

5.Tighten the setscrew on the underside of the armrest. See figure 19.

6.Turn the rear shroud fasteners one-quarter turn in any direction. See figure 6.

7.Remove the rear shroud.

8.Plug the controller connector(s) into the power base. See figure 7.

9.Reinstall the rear shroud. Turn the rear shroud fasteners one-quarter turn in any direction.

10.Route the controller cable so that it cannot be pinched in the seat hinge.

11.Secure the controller cable to the armrest receiver with wire ties. See figure 12.

	SEAT
SETSCREW	LATCH
	SAFETY

Figure 11. Universal Mounting System

WIRE TIES

Figure 12. Remote Plus Controller Routed on a Contour Seat

Jazzy 600 XL www.pridemobility.com 21