Pride Mobility Jazzy 600 XL To clamp the quick release fastener, Foot Platform Angle Adjustment

Models: Jazzy 600 XL

1 43
Download 43 pages 49.36 Kb
Page 25
Image 25
To clamp the quick release fastener:

V . C O M F O R T A D J U S T M E N T S

two states: clamped and unclamped. When the lever is open, the quick release fastener is unclamped. When the lever is closed, the quick release fastener is clamped.

To clamp the quick release fastener:

1.Make sure the lever is in the open position.

2.Turn the nut clockwise until it is snug.

3.Rotate the lever until it is in the fully closed position.

NOTE: If the lever will not rotate to the fully closed position, then turn the nut counterclockwise one-quar- ter or one-half turn.

SETSCREW

Foot Platform Angle Adjustment

You can adjust the angle of the foot platform with a hex key. See figure 17.

To adjust the foot platform angle:

1.Flip up the foot platform and locate the setscrew.

2.Loosen the jam nut that secures the setscrew.

3.Turn the setscrew counterclockwise to raise the front of the footplatform.

4.Turn the setscrew clockwise to lower the front of the foot platform.

5.Tighten the jam nut to secure the setscrew.

Controller Position

You can position the controller for either left-hand or right- hand use.

WARNING! Do not place the controller cable so that it can be pinched in the seat frame or the power base frame.

To change the controller position:

1.Turn off the power to the controller.

2.Loosen the rear shroud fasteners and remove the rear shroud.

3.Unplug the controller connector(s) from the power base.

4.Cutthewiretie(s)securingthecontrollercabletothearmrest.

5.Flip up the armrest and loosen the setscrew. See figure 19.

6.Slide the controller out of the armrest.

7.Loosen the setscrew in the other armrest.

8.Place the controller in the other armrest.

9.Tighten the setscrew to secure the controller.

10.Route the controller cable to the back of the power base and plug in the controller connector(s).

11.Reinstall the rear shroud and tighten the fasteners.

12.Use a wire tie to secure the controller cable to the arm- rest. See figure 12.

Figure 19. Underside of Armrest

SFR RELEASE LEVER

FOOTREST

EXTENSION

ADJUSTMENT

SCREWS

Figure 20. Swing-Away Footrests

RELEASE LEVER A

RELEASE LEVER B

LEG REST

EXTENSION

ADJUSTMENT

SCREWS

Figure 21. Elevating Leg Rests

Jazzy 600 XL

www.pridemobility.com

25

Page 25
Image 25
Pride Mobility Jazzy 600 XL To clamp the quick release fastener, Foot Platform Angle Adjustment, Controller Position