![](/images/new-backgrounds/1077164/771643x1.webp)
PSW26PSW
GE Profile™ ENERGY STAR® 25.5 Cu. Ft.
To Remove Top Caps and Doors on PSW26PSW
Step 1: the refrigerator. Remove two screws, one on each side at the rear of the top cap. Lift off and remove top cap.
Step 2: Open both doors. Remove one screw on each side of the toekick. Pull forward to remove toekick.
Step 3: On the freezer door, disconnect water line coupler by pushing against the collar on the left side. Disconnect wire harness.
Step 4: Use a Torx
Step 5: Place refrigerator onto a hand truck, upright and against one side. Move refrigerator to the installation location.
Step 6: Carefully lower doors onto bottom hinges. Be sure to route the tubing and electrical connector through the bottom hinge. Reinstall top hinges.
Step 7: Place cap over the top of the refrigerator. Reinstall the original screws in the top and back of the cap.
Step 8: Reconnect the wiring harness and waterline.
1.
Hinge Screws
4.
3.
2.
toekick Screw
Wire Harness Water Line Coupler
For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.
Listed by
Underwriters
Laboratories
As an Energy Star® partner, GE has determined that this product meets the Energy Star guidelines for energy efficiency.
Specification Revised 7/07 | 210259 |