Connecting the antennas
Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals.
| AM loop antenna | Indoor FM antenna | |||||
| (included) | (included) | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
TUNER
AM
ANT
GND
75Ω UNBAL.
FM
ANT
Ground (GND terminal)
For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.
■Connecting the AM loop antenna
1Set up the AM loop antenna, then connect it to the terminals on this unit.
CONNECTIONS
Notes
•The AM loop antenna should be placed away from this unit.
•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.
•A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about outdoor antennas.
■75-ohm/300-ohm antenna adapter (U.K. model only)
1Open the cover of the
included 75-ohm/300-ohm antenna adapter.
2 Cut the external sleeve
of the | 11 mm | |
8 mm | ||
cable and prepare it for | ||
6 mm | ||
connection. |
|
3 Cut the lead wire and
remove it. | Lead wire |
|
4Insert the cable
wire into the slot, | Clamp | Clamp |
and clamp it with |
| |
|
| |
pliers. |
|
|
| Insert wire into |
|
| slot. |
|
5Snap the cover
into place.
■FREQUENCY STEP switch
(Asia and General models only)
PREPARATION
2Press and hold the tab to insert
the AM loop antenna lead wires
Because the interstation frequency spacing differs in different areas, set the FREQUENCY STEP switch (locating on the rear panel) according to the frequency spacing in your area.
AM FM
into the AM ANT and GND terminals.
3Orient the AM loop antenna for the best reception.
•North, Central and South America: 100 kHz/10 kHz
•Other areas: 50 kHz/9 kHz
Before setting this switch, disconnect this unit’s power cord from the AC wall outlet.
English
19
