■IMPEDANCE SELECTOR switch
CAUTION
Do not change the setting of the IMPEDANCE SELECTOR switch when the unit power is switched on, as doing so may damage the unit.
If this unit fails to turn on when STANDBY/ON is pressed on either the front panel or remote control, the IMPEDANCE SELECTOR switch may not be fully slid to either position. If this is the case, slide the switch all the way to either position when this unit is in standby mode.
Select the switch position (left or right) according to the impedance of the speakers in your system.
CONNECTIONS
IMPEDANCE SELECTOR
SET BEFORE POWER ON
IMPEDANCE SELECTOR switch
PREPARATION
Switch position | Speaker | Impedance level | |
|
|
| |
|
| If you use one set (A or B), the impedance of each speaker must be | |
|
| 4 Ω or higher. | |
| Front |
| |
Left | If you use two sets (A and B), the impedance of each speaker must be | ||
| |||
|
| 8 Ω or higher. | |
|
|
| |
| Center, Surround, Surround back | The impedance of each speaker must be 6 Ω or higher. | |
|
|
| |
|
| If you use one set (A or B), the impedance of each speaker must be | |
|
| 8 Ω or higher. | |
| Front |
| |
Right | If you use two sets (A and B), the impedance of each speaker must be | ||
| |||
|
| 16 Ω or higher. | |
|
|
| |
| Center, Surround, Surround back | The impedance of each speaker must be 8 Ω or higher. | |
|
|
|
English
21
