Thermador 9000039271 Dishwasher Preparation, Removing the Toe Panel DWHD94BF Regular Toe Panel

DISHWASHER PREPARATION (continued)

B

A

Figure 12

Junction

Box Cover

Figure 13

Removing the Toe Panel

DWHD94BF Regular Toe Panel

The toe panel is loosely attached with tape. Remove the tape and pull the toe panel away from the dishwasher. Set the toe panel aside. It will be reinstalled later.

DWHD94BP and DWHD94BS Base and Toe Panel

The base and toe panel are in place on the dishwasher, but are not attached. Remove the toe panel first, as shown in Figure 12, letter A, then remove the base, as shown in Figure 12, letter B.

Installing the 90° Elbow Fitting

NOTE: The 90° elbow fitting is not supplied with the dishwasher, and must be purchased separately. If the dishwasher’s hot water supply line is to be copper tubing, make certain the elbow has a compression fitting.

Apply Teflon tape or other pipe sealant when required.

Orient the hot water supply connection leg of the elbow toward the channel opening in the dishwasher base.

Junction Box Preparation

1.Remove junction box cover, Figure 13, by lifting the junction box cover up and off.

2.Remove the strain relief plate by removing the screw at the back of the junction box, as shown in Figure 14, letter D and sliding the strain relief plate out.

3.Set the junction box cover, strain relief plate, and screw aside. They will be re-installed later.

Junction Box

D

Figure 14

8