Thermador 9000039271 installation instructions Placing the Dishwasher, Securing Dishwasher

PLACING THE DISHWASHER

14"

(355mm)

21"

(533mm)

Figure 16

A

Figure 17

B

C

Figure 18

A

B

1.Straighten and position the hot water supply line and the electrical supply cable as shown in Figure 16 so that they will align with their channels under the dishwasher base.

2.Position the dishwasher close enough to the enclosure so that you can run the dishwasher drain hose to the under sink drain connection. Make certain that the hot water supply line and the electrical supply cable are in their channels under the dishwasher base, as shown in Figure 17, letter A.

3.Place the dishwasher directly in front of the enclosure.

4.Perform a level check as shown in Figure 17. Adjust the rear leveler by turning the center screw at the front of the dishwasher, as shown in Figure 18, letter B. Turning the screw clockwise raises the rear of the dishwasher. Adjust the front levelers by turning them with a screwdriver, as shown in Figure 18, letter C. Turning the levelers to the right raises the dishwasher. If additional height is needed, shims may be added under the leveler feet.

5.Push the dishwasher into the enclosure.

SECURING THE

DISHWASHER

Drive the mounting screws through the holes in the mounting brackets, as shown in Figure 19, letter A for Top Mount, or as shown in Figure 19, letter B for Side mount.

Figure 19

10