Bushnell 110833 Install, Batteries Optional, SD Card, Camera, Binocular, Optics for, Your Eyes

QUICK GUIDE: BUSHNELL IMAGEVIEW 110833/110834

1 Install	Insert 2 AAA batteries (see “Specifications”) into the battery compartment on the bottom of the camera pod
Batteries &	(Note polarity indication inside). An SD memory card (optional, use up to a 1 GB card) for increased photo
(optional)	storage capacity may be installed in the card slot, located at the back of the camera pod (Insert card with label
	side facing down, pushing lightly until it clicks into place. Push the card lightly in again to remove).
SD Card

2Turn On the Raise the LCD display, pulling up at the indented areas on each side. Press and hold the POWER button

Camera	until the red power LED stays on, then let go. You will see a “Clock Set” screen when the camera is used for
	the first time-refer to “Camera Setup” for details on setting the date and time, or press the Menu button with
	“Cancel” still selected to set this later. Press “Display” to turn the LCD back on -you will see a “live” preview
	of the image from the camera lens, located between the binocular objective lenses. You can also manually
	turn the display off by pressing the Display button-it does not need to be on to take a photo. The entire
	camera will automatically turn off after one minute (this can be changed using the “Auto Off” option in the
	Setup menu) if it has been inactive (no buttons pressed). To turn power off manually, press and release the
	POWER button. The default camera settings will provide optimum quality under most conditions.

3Format the If you inserted an SD card earlier, format it before beginning to take photos if you are using it in the ImageView for the first time. Press the View button below the LCD display. Press the Menu button in theSD Card

(optional)	center of the silver keypad. Press the Down arrow key once to select “Format”. Note the warning that this
	will erase all data on the card-make sure you have downloaded all photos from a previously used card. Press
	the Right arrow key, to select “OK”. Press Menu to format the card (display shows “Formatting”). When the
	display reads “No File”, press the View button to return to the live preview display mode.

4Set the Roll down the rubber eyecups if you are wearing glasses. Adjust the spacing between the left and right

Binocular	binocular tubes while looking through the binocular until the view appears as a single circular image. Then,
Optics for	find a distant object with fine detail, and adjust the center focus knob until the object appears sharp through
	the left eyepiece . Now look through the right eyepiece only. If the object does not appear equally sharp,
Your Eyes
	rotate the right eyepiece (diopter adjustment) until it is also sharp. Once set, you no longer need to move
	this diopter adjustment, and may simply focus using the center focus knob.
	3