English
14
CD
Selecting a desired track
Selecting a desired track when playback is stopped
1Press S or T (or ’/ ‘on the remote control) until the desired track appears on the display.
2Press PLAY ƒto start playback.
ªThe selected track number and elapsed playing time appear on the display.
Selecting a desired track during playback
•Press S or T (less than 0.5 seconds) until the desired track appears on the display.
ªThe selected track number and elapsed playing time appear on the display.
•If you press S (less than 0.5 seconds) it will skip to the beginning of the current track and play the track again.
Searching for a particular passage during playback
•Press and hold SEARCH S or T (or ˆ/ ‡on the remote control) until the desired passage is located.
ª The volume will be reduced.
•Play returns to normal when SEARCH S or T is released.
Programming Tracks
Programming tracks of a loaded CD is possible when playback is stopped. The display will indicate the total tracks stored in the program. Up to 40 tracks can be stored in the memory in any order. When 40 tracks are stored and you attempt to store another track, the display will show “FULL”.
1Load the desired discs in the disc trays.
2Press PROGRAM to start programming.
ªThe PROGRAM flag starts flashing.
ªIt will cancel any previously selected repeat mode.
3Press the 3 CDC button to select the disc.
4Press S or T (or ’/ ‘on the remote control) to select the desired track.
5Press PROGRAM to store the track.
• Repeat steps 3 to 5 to store other discs and tracks.
6Press STOP once to end programming.
ªThe total number of tracks programmed and total playing time appear on the display.
Notes:
–If the total playing time is more than
“99:59“ or if one of the programmed tracks has a number greater than 30, then
–During programming, if no button is pressed within 20 seconds, the system will exit program mode automatically.
Reviewing the program
Reviewing of the program is possible only when playback is stopped.
•Press S or T repeatedly to review the programmed tracks.
•Press STOP to exit review mode.
Playing the program
1Press PLAY ƒto start program playback.
ª“PLAY PROGRAM” appears on the display.
ªThe track number and elapsed playing time of the current track will
appear on the display.
•If you press REPEAT during program playback, the current track or all programmed tracks will be played repeatedly.
ª“TRACK” or "PROGRAM" will be displayed.
ªThe REPEAT and PROGRAM flags will be
displayed.
2Press STOP to stop program playback.
Notes:
–If you press any of the CD DIRECT PLAY buttons, the system will play the selected disc or track and the stored program will be ignored temporarily. The PROGRAM flag also will disappear temporarily from the display. It will reappear when playback of the selected disc ends.
–REPEAT DISC mode will be cancelled when program playback begins.
Erasing the program (when
playback is stopped)
•Press STOP.
ª“PROGRAM CLEARED” will be displayed.
Note:
–The program will be erased when the system is disconnected from the power supply or when the CD carousel is opened. If the CD carousel is opened, the tracks belonging to the outer two trays will be erased and the display will show “TRACKS CLEARED”.